Trade Feeler 95 BMW M3

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Location
United States
I have a 95 M3 that l was considering trading for 1st gen runner or a 60 series. Up front l will say that the car has an R title due to the fact that it had been stolen. It has some minor cosmetic damage on the drivers side. It is purely cosmetic. The car drives fantastic, gets great milage and runs smooth. It has the famous vanos tick but the motor is in fantastic shape. It's hellrot red with black leather interior. Has M-motorsport LTW wheels on it as well. Car is located in NW PA. Here are a few pics.

DSC01449.jpg

DSC01443.jpg

0604001824.jpg

DSC01448.jpg

DSC01451.jpg

DSC01453.jpg

DSC01454.jpg

DSC01450.jpg

DSC01455.jpg

DSC01456.jpg
 
Bump. Lots of vies..no interest. Is it the fact that it has an R title?
 
Might be no price (required per mud rules) or mileage.

GLWS... nice car!
 
Thanks, not really sure on a price. Really just want to trade for a 1st gen runner. I would say 6500 bucks. The car has 114,000 miles but this is my dd so it changes all the time.
 
I've got a cruiser I might consider trading: 83 60, SOA + 4" of MAF springs, riding on 37" Iroks on Trailready beadlocks.

By no means perfect but a great start. Primary issues right now: It's too big to fit in my garage (I'd throw in some stock springs if you want), the front axle wasn't cut and turned right (I have a properly cut/turned housing ready to go in) and the gearing is bad (I have 4.11 3rds which will work fine with 35's and ok with the 37's). Paint is rough but rust isn't bad for it's age. Interior is ok.

It's either getting traded for something or I'll get it to where I want it over the winter and drive the hell out of it for years to come. PM if interested.
 
I'll email pics tonight when I get home from work. Normal surface rust on frame, some on body. The only place that had any rust through was the rear passenger wheelwell, just a little notch section. Located in Fort Collins, CO.
 
Nice looking rig but it might be a bit more of a project than l want. GLWS
 

Users who are viewing this thread

Back
Top Bottom