Purchased new in May 2019 and installed on my LC for approximately 15 months. These were shipped raw and coated with an Epoxy primer and Rust-Oleum spray on truck bed coating. The bed liner held up OK, but it has worn off in spots where they were consistently used as steps. Also, there are spots on both sliders where the metal made contact with the plastic fender liner or pinch weld and the finish wore off (I hung them a bit too high). They could use another coat, or a trip to a powder-coater to be stripped and coated (this would've been my choice if I were keeping them). Hardware is included and in good shape, these fit both the LC and LX.
$500 obo, local pickup only (these weigh 70-80lbs each, so shipping would be cost prohibitive).
More information on Metal Tech's site: OPOR 100 Series Land Cruiser/LX470 Sliders (Raw Steel)
$500 obo, local pickup only (these weigh 70-80lbs each, so shipping would be cost prohibitive).
More information on Metal Tech's site: OPOR 100 Series Land Cruiser/LX470 Sliders (Raw Steel)
