Bump stops for 1st gen Sequoia (1 Viewer)

[OnespeedTRD]

Tried the search, didn't come up with anything.

Looking at the front bumpstops on my 2007 Sequoia I noticed there are two on each side, one for each arm of the LCA. For those running aftermarket front bumpstops did they come with a set of four or do you just replace the front pair or rear pair only?
Anything out there besides the Durobumps or Timbren options?
What are folks using for the rears? I've read that factory GX460 rears work, but I have a set and they don't seem any longer than the stock Sequoias.

 

[ChewBaca]

Hey,
I was looking into switching out my bump stops and saw your post, What did you end up doing? Any recommendations?

Thx!

 

[turbo8]

Hey,
I was looking into switching out my bump stops and saw your post, What did you end up doing? Any recommendations?

Thx!

There are these as well.

https://www.perryparts.com/category/toyota-sequoia-1st-gen

 

[TheBussman]

Running the Perry parts as well. Very happy with them on the sand dunes trip, got some air a few times and were defiantly being used.

 

[ChewBaca]

Nice, I just received my front and rear BS from Perry Parts. I will get them installed next week. Thx for the info.

 

[FJGuy]

I have a set of Perry's for my Sequoia and will have them on this week as well. A friend with a GX loves his.