Bolts....

[jmdaniel]

Hey folks, is there a good place in Austin to find factory bolts for an LC? I was putting in some new seat belts this weekend, and found a bolt on the roll bar that had seen better days. It's the one you can see just above the headrest in this pic, and is a thread cutter 10mm, I believe. I went to Fastenal today and picked up one that would work, but I'd kind of like to replace what came out with the same. IHMUD has a great section called Nuts and Bolts, but where do you guys go when you need a fastener?

 

[warpdriv]

You can look in the classifieds for someone parting out a 40.

 

[green grass hopper]

if you have it in hand you can stop by the shop and look in my bin. i bet i would have one or go to toyota and get a new one.

 

[worldspan]

Austin Bolt Co

2001 Rutland Drive, Austin, TX 78758-5421 (512) 836-1611 ‎

Hey folks, is there a good place in Austin to find factory bolts for an LC? I was putting in some new seat belts this weekend, and found a bolt on the roll bar that had seen better days. It's the one you can see just above the headrest in this pic, and is a thread cutter 10mm, I believe. I went to Fastenal today and picked up one that would work, but I'd kind of like to replace what came out with the same. IHMUD has a great section called Nuts and Bolts, but where do you guys go when you need a fastener?

 

[jmdaniel]

if you have it in hand you can stop by the shop and look in my bin. i bet i would have one or go to toyota and get a new one.

Thanks, Edwin. I'll stop in and see what you have. It's pretty specialized, so should be easy to see if you have it or don't.

 

[Sea Knight]

Nuts 'n Bolts

Austin Bolt Co

2001 Rutland Drive, Austin, TX 78758-5421 (512) 836-1611 ‎

If Edwin doesn't have it, x2 on Austin Bolt.

Also, if you aren't in a hurry, McMaster-Carr has it all...

McMaster-Carr#

 

[jmdaniel]

Edwin took care of me. Thanks!