My 100 wouldn’t start on a cold morning this week. I jumped battery and it started.
I replaced the battery with a Duralast Gold 27.
The last two times I’ve driven it, a major vibration/shaking develops when I was at a stop light, and right after pulling into a parking spot. It went away...
Bought this near new from Toyota h55f from an employee at Mudraks who used it for 8k miles and then popped a cummins/nv4500 in his 60. Pulled this one out. George of Valley Hybrids rebuilt another split case i had and upgraded the case with all the bells n whistles/McNamera gear etc. and...
I bought an 80 with a bad head- and the owners records showed Toyota replacing the bottom end with a new $6000 block at a Toyota dealer.:oops: I pulled the motor/trans and kept it as a spare and now i dont need it. I pulled the head to use for another project and also just to see what an...
Around 200k miles on my GX470 and for a year or so Ive been having a delayed shift from R and N into D. I replaced the drive shaft and it seemed to help a little, but the delay was still there from time to time. (I also flushed the trans fluid and replaced the filter about a year ago but the...
Anyone have any luck convincing a Canadian dealership to apply the 8spd transmission update - TSB 0209-17 (LSB 0118-17 for Lexus). My 2017 LX acts like it needs the update but the dealership says they can't do it because the above LSB is written for the US market.
HAPPY NEW YEAR! So, I was hoping the kind folks on here could maybe help shed some light on what hardware my 1988 4runner currently has.
I was poking around under my 4runner, cause why not, and noticed I have the chain driven t-case (I believe) vs the desired gear driven. I can see I have...
I have a 1995-1997 80 series I’m parting out. The engine has 305k on it. The wiring harness was cut before I purchased the truck so the condition of the engine is unknown. This would make for a good rebuild motor and accessories.
Entire 1fzfe long block with all accessories and ECU $750 OBO...
Good day all,
Happy new year.
I'm having an issue with my a440f transmission. When I just bought it and restored it. It was fine. I then had an overheating issue and then the clutches started to slip.
I got the transmission repaired and rebuilt. After the rebuild when the transmission shifts...
Shifts well, no known issues. You are welcome to try out the transmission. $700, I can deliver the car locally to the Los Angeles area for you to remove and reload onto my trailer.
Need advice from the experts. The last couple of times I've started my '75 40 after sitting for a week, I've had trouble shifting into reverse. It feels like the clutch hasn't disengaged reverse gear which feels like it's turning. A couple of times, I've also had trouble shifting into 1st or...
I have an h151f transmission that I purchased on a work trip and shipped home. Very rare transmission that was never sold in the US. I was going to put it in an 80 series land cruiser but figured I don’t need another project. I’ve gone through the transmission and replaced all the bearings and...
I have a stock distributer and button, with stock cap and NGK wires with stock coil off my 1985 fj60. All in working condition when I remove them 5 years ago to run the TPI Firecracker kit. I’m located in Ocoee Florida shipping is flat rate either $17 or $20 USPS and $300 for the parts.
Hey all, I have a 2001 LC with 318,000 miles. Have owned for 4 years now and never had any issues with the Transmission. Over the past few weeks, I have had an intermittent issue when cold starting (seems to happen more when it has been sitting for a few days).
I crank it and place it in...
Greetings and happy holidays.
I have recently purchased an 80 series and want to know what transmission the vehicle has (particularly for determining which transmission filter to buy) as I begin to baseline it.
The PO did a door jam paint job with a bed liner style paint to match the color of...
I have a 2001 LX470 that needs a transmission. I am in Northern California near San Jose. I'm looking for a good shop in the area to R&R the transmission. Any suggestions appreciated.
Have a decent hood and driver side front fender from a 96 80 series here in NE PA. Free to whomever can pick them up. Also have a good transmission free, too. Best to email me shmukiter@pa.metrocast.net
Hello mudders,
I am working on developing a trans control harness and tune for my 1993 USDM 80 series so I can use a Haltech standalone ECU. I have been able to successfully map A34x series transmissions in Tacomas and for the most part the A442 (AW450-43LE) looks to function the same really...
Hello All, I have a 2F engine and 4 speed transmission from a 1985 FJ60 for sale. I will sell them separately or together. These came out of a truck with 180k miles on it. The transmission shifts nicely and is in nice shape. The engine runs well with good compression but burns a lot of oil...