transmission

ive had a hard time getting the trans pan to seal, on a 91 4runner. and recommended sealants or tricks? i have thought about just getting a new pan

I have a 14BT and just picked up an h151F. Is there a go between bellhousing? I searched but came up nada. Thanks

Hello all, super happy to finally be part of this group, I'm a longtime lurker. Always been a 4runner fan, but out of the US now and just bought a new-to-me 1990 FJ80 5-speed manual (pics for love), and am having some trouble with shifting into 2nd gear. Going up from 1st isn't an issue, but...

Hey everyone. I’ve been using my ultra gauge to keep track of my transmission temps on my 2013 LX with the 6 speed AB60F. I’ve been seeing torque converter temps as high as in the 230s when accelerating up grades during cross country highway trips. Pan temps are normally around 185 - 195...

1993 Toyota 1KZT-E engine, trans, transfer case out of a KZN130 Hilux Surf. Motor has 69k miles. The motor compression tested 450-455psi each cylinder. EGR appears to be intact. Marketplace video and listing This surf tipped on its side, and I acquired it from the owner at the time. I pulled...

I drained the pan, 2004 100 series. I got about 2.75 qts out. I went to fill and realized I wasn’t prepared- no dipstick and I didn’t have the right kind of transfer pump or the 24mm socket. I found a small 12mm plug in front of the linkage right above the pan and managed to get the new fluid in...

H151F 5 speed manual, with 1FZ input shaft and Bellhousing setup. This came out of a US spec, 1FZ powered 80 series, it was swapped into the truck a couple years ago. Running great when removed. No known issues. I helped swap it into, and out of the truck myself. Includes...

So nearly two years go I pulled this off my HJ60. I stuffed this away and labeled it "transmission - support plate". Cannot figure out where this goes back, anyone who knows or has a pic of their own? 1984 HJ60, 2H, H55F

Hi all, I'm new here. I just purchased a 1993 Prado and I'm having an issue with the transmission shifting from 3rd to 1st when I come to a stop. It's an automatic. I can shift it into L and 2nd with no issue from the start off, but 50% or more of the time, it won't shift back down into 1st...

Hi there, having troubles getting my speedo to work. I first replaced the cable and speedo gear within the transmission (which was shredded when I bought the cruiser) I replaced the gear like for like (a 16 tooth gear). Again after one drive it shredded it. Ive replaced the whole instrument...

Over the past few days I have experienced great fear and relief on my 100. Sunday night when pulling out of a parking lot, I lost power and it sounded like I was dragging a giant metal anchor underneath me. It almost felt like I was high centered for a moment, but I was able to get into...

Afternoon gents, Long time lurker first time poster. Back in Jan 2023 I bought this 1973. The PO had done a (semi botched) 1978 SBC 305 swap. I have since proceeded to replace or rebuild every component on it, to include: -POR-15 coated frame -Skyjacker Suspension (3 inch lift) -Rebuilt front...

2004 w 210,000 miles, drives great shifts great but takes a minute to get into drive during the first start of the day, after that its good the rest of the day. I already took it to a shop to check Transmission fluid level and added some Lucas treatment in there. Anyone have any thoughts?

On an automatic transmission system, where can i find the type/name of the transmission, e.g. A442F? Is it engraved or printed anywhere on the transmission? I seriously want to confirm the transmission type on my car directly without relying on the label in the engine bay. Many thanks.

Title is the basics of it. I’m looking for advice on diagnosing the problem, and getting it fixed. Currently maybe every 10th change down I’ll need to give it a bit of a bump to shift from the middle of the box to the 1st/2nd side of the box. Not a huge issue at the moment, but I am conscious...

These are not yet pulled, but will be in late March / April and thought I might test the waters to see if there is any interest in them. The engine is a 1FZ-FE out of a LX450 swapped into a 97 Land Cruiser about 16 years ago. Mileage on the engine is at least 180k, but likely much more. Of...

Got an extra new H55f here, $2600 until the end of the month. I normally sell these for $2750. Can ship anywhere. I also stock all other additional parts to make this work in your vehicle, hardware, transfer cases, oiler cups etc

4 speed out of a 1974 FJ40. $350 plus any shipping cost.

I have both sitting here and the 442 is much heavier than the 343. How is the 343 as much transmission as the 442? Obviously there is less metal involved.

1987 FJ60 Complete Motor, transmission and transfer case(except drive shafts) on Frame. 307000 miles on well maintained motor. I am using the body for an LS3/80 Series Frame swap. Price: $3000 you can contact me (LYLE) at (ultracyclist@yahoo.com or text at 215-280-27450) links for complete video...