rear

Hey team, When I bought my Cruiser, it came with rear seats, but no belts, or the vertical bars by the window that they should attach to: Picture is of a friend's Cruiser with identical belt mounting points to the floor and with top pivot at the vertical bars. Only difference is that my seats...

Hey all, i did myself a mischief and had 3 out of 4 bolts come loose on driveshaft on a long drive and managed to bend the rear output shaft on the gearbox. I was wondering if anyone could answer a couple questions i have: 1: Will the gearbox need to be dropped and stripped partially to remove...

Got these with a parts lot: they are 555 brand. Part number is stamped on the drum. I couldn’t use them for my project, because the studs were too short for the extra thick mounting face on these. They are extremely heavy duty…. And will be heavy to ship…. 100$ plus shipping

I'm getting ready to do some body work on my 73 FJ, I want to replace the rear sill that's rotted away and do some patch panels in the corners. The rest of the tub is not that bad so I don't want to pull it off the frame. My question is can I replace the rear sill without pulling the tub?

Hey all, I am looking for a pair of the rear tire carrier mount castle nuts for my 65 FJ40. Thanks for any help/leads! Cheers

I had a rear axle seal fail while on a trip, lighting up about every light on my dash so I’m going to replace the sensors on each side, what is this sensor called?

Had an incident that requires replacing the entire door. Anyone selling one?

Trying to finish up brake job on ‘77. Looking to see if anyone has a new OEM rear brake drum, part number 43501-60010 sitting on the shelf they would part with. Called all the local Toyota dealers, all are giving me same answer/- part is on back order, might be one in Houston, could be 4...

right rear light cluster for 2020 (so back I don’t know how far). Lens is cracked but all bits are there. Seems a shame to throw a $1k part in the trash when rest is fine. I’m in Vancouver BC but can post it from northern WA. Send me a USPS label and it’s yours, I will box it up and ship it off.

Hi all, I have a 2013 lx570 with a rear wiper issue. No tension to the rear windshield, kind of flops around if you will, motor is still good. Popped the rear cap off, moved the arm up and to my surprise it pulled right out. Is this normal?

I removed my 3rd row seats and got a new mat, so I have the LX570 3rd row mat. From a '13 LX. Has the holes cutout for the swing down 3rd row seats. $25. Located in Golden, CO. I'll get a pic up later today.

I am wondering if anyone can help with a part number or vehicle to search for the brake hose pictured below. I am the new owner of a '78 40 and the PO did a rear disc conversion. I am restoring and have not been able to find the right hoses for the rear end. I looked in the FAQ of the forum...

Spent the whole afternoon on a new bearing and seal. Cracked the extension housing on reinstall. Either misaligned the pump drive or the pump spacer fell down. Doggone it. Pics of the part that went well:

I have vibration that gets pretty noticeable around 60mph. It feels like it is in the back. Steering is solid and no vibs in steering wheel. Had this before I put new tires on and balanced. I checked the drive shaft and found about twenty thousands run out on the barrel and the yoke is so...

looooooking for a drivers door and rear lower hatch for an ‘up FJ62.

I'm about to go replace the output seal on my transfer case and trying to mentally walk through the job before tearing into it. Can the rear extension housing be removed with the crossmember still bolted to the frame rails? Planning to replace the output seal, bearing, snap rings, speedo...

I would like to fabricate and replace the rear crossmember on this FJ45. It is a little beat up but not corroded. Not full understanding how the frame rivets work and if I were to grind them off…what would be the process in riveting the new crossmember back on? Can it be bolted or is riveting...

Replaced the rear shoes and drums on the 75 in july. New oem drums, shoes from $or. For the past two months now ive been chasing something that sounds metallic eating something else metallic. Ive been in there no fewer than 4 times looking for something out of place...nothing is showing wear and...

For sale: Rear third row seats from a LX450 in good condition that were no longer used. Will fit toyota land cruiser. Location: Berkeley CA 94710 $100 picked up. Will ship at buyers expense.