fuel

Hi guys, I just had a bad experience and I hope someone can help me with this. I just took the car to a shop to adjust/repair the fuel pump for my HDJ80 (1HD-T) and had a very bad experience... I´ll start since the beginning, 1 year ago the car was burning eyes, too much diesel was being burn...

Hey there, frequently scanning this website, i'm at first time posting here. i have a question about 1hd fuel pump leakage. there is a overflow screw under the diaphragm cover. The screw has a rubber cup with a short hose. it looks like some fuel may comes out from the hose occasionaly. in my...

Hey-o! I'm talking the plumbing on the pig... redid all the clutch and brake lines, and now it's the fuel systems turn... Cleared out the factory hard lines with compressed air, ran new rubber lines where needed, and cleaned and coated the tank. It's all installed and hooked up to the mbz...

my engine guy is pushing for a Holley EFI system, anybody have any feedback

I have a 1985 toyota pickup 22re efi. I bought it about a year ago after sitting for a year. I gave it a basic tune-up (spark plugs, wires, cap, and rotor). It ran rough for a little until it started missing on the second cylinder, after replacing the injector and fuel filter, still not fixed so...

SoCal I have a few non leakers from running cars, from different years, no rust or corrosion NO SHIPPING on Gas Tanks or skid plates. These are stock factory tanks. Filler pipes are not available. Gas tank doors are avaialable. Private Message me for your needs.

Front seats with headrests, seat frames and center console. $300 Radiator mount / support $70 Metal fuel tank with new sending unit $150 Metal fuel tank shroud / cover $150 Original gauge cluster $200 New poly fuel tank in box $150 If these prices are way off please let me know. I don't...

Hi guys, I've been searching all the terms I could think of for the last 2 weeks trying to figure out what I can test or do to remedy my situation. Nothing really stuck out. 2 weeks ago, the truck was running the way it should. Then overnight it seemed, its lost what I would say about 10%...

Hi fellas, I have a problem I need help with. My 100 series 1hz non turbo is only squirting fuel from 4 of the 6 ports on the pump. The other 2 have little or no fuel coming out. What could be the problem. It starts and idles but won't rev out. I run bio diesel and wonder if this has a bearing...

Not interested in building a 2FE or doing a 3FE or other swap. I'd like to add FI to my 2f with the primary goal being to not stall out on steep inclines while wheeling (as I just did WAY too often in Moab). I don't care about street performance, horse power, fuel economy etc etc. It just needs...

The following lays out the decel fuel cut circuit (Idle Cut Solenoid). Three of the last four carbs I have gone through all had the gasket shown in the pic installed to where the vacuum wasn't getting to the upper left carb vacuum port (decel port). I punched the two holes in this one.

I noticed the low fuel warning light started to light up a lot earlier than usual, has anyone experienced this before? See attached photo.

hi all, I am replacing the filler neck on my 1994 80 series. I have the old one out. It was so rusted I ripped it in half to get it out. Looking in past threads I see the new replacement has to be sectioned to install it unless I pull the body off the frame. (Thanks Toyota) That's not...

So, there's been a persistent smell of fuel which I finally decided to track down. This truck has been touched (and out of my hands) by several different shops in the last 3 or 4 years. I only recently got it back. One of the shops moved the fuel fill location higher up so I could actually fill...

New in box sender 9/72-9/77 FJ40 $75.00 shipped. Thanks, John

Looking into a wheel upgrade. Considering a set of wheels share a pretty similar in design look between the Method Racing and Fuel brands. Are there any substantial quality differences? I noticed that one wheel weighed 13 lbs more the other, which may have been a typo or a material difference.

Short summary: I reluctantly tried Lucas Upper Cylinder Lubricant fuel additive on my 100-series, expecting snake-oil results. Instead, I consistently found equal or better mileage with lower-grade fuel, and what appears to be less wear-and-tear on my engine oil. I am now a True Believer, and...

I should have known, but discovered that the FJ60 fuel supply and return lines are the same diameter, so the grommets won't work for installing the fuel lines from my FJ62, which are two different diameters. So I decided to clean up my FJ62 clamps and use those, which have like-new grommets...

I'm looking for the stock bracket that holds the lower fuel filter (between the tank and the fuel pump) to the chassis. My unit is a 1974 FJ40. Dave Dillon buscando13@sbcglobal.net 619-929-1944

Hello all, I'm asking what is probably a silly question, but I've spent the past half hour searching with no luck. I bought an FJ60 without an engine. I'm looking to find out which fuel hardline is which - supply versus return - under the truck. There are two hard lines mounted one above the...