front

Hello all. Banging noise coming from front output shaft area. A couple question?. Any ideas? can I separate the front output cone from case to inspect where the issue is or would it be better to just pull the whole case? Would you pull trans and case together or just pull the case? Thank...

Selling a pair of FJ60 seats with headrests out of a 85 FJ60. The pair of seats and headrests are $500 plus shipping. Both seats come with their seat tracks Seats are in New Jersey

Anyone looking to sell their 100 series 03-07 ARB deluxe front bumper (# 3413190)? I'm in NW Arkansas and can travel couple of hundred miles to pick it up. I would also be open to trading my 04 LC bumper in grey plus cash for the ARB.

Bought an LX months ago, and both front windows appeared to be completely clear. Previous owner must've had a car break-in because the passenger side is not OEM. Tracked down a seller who sells the factory matching 30% Viper Ceramic Bronze or whatever it was called. Had it installed. The...

I've been lurking around this forum for a hot second now and you all have been an imense source of help with trying to fix up the 1977 FJ40 I've inherited. So, I'd like to first off thank everyone who contributes to this forum. A little piece about my 40: as stated, it's a 1977 FJ40 that has (I...

I’m looking for a front passenger door that would fit my 1989 Toyota land fj62

I looking for a undamaged front driver’s side fender flare for 1997 80 series Land Cruiser

Small rips here and there. Foam appears to be good. Would be good candidates for recovering. Free to anyone who wants to stop by and pick them up. Typical grey color. All hardware included.

Looking for a front bench 60/40 seat set from an older 40. Any condition considered. Preferably closer to KC as shipping will be tough. Am also needing the following for a '73 40: -wiper arms -pillar mount mirrors -license plate bracket/light -most electrical switches and heater controls...

Looking for the buckle portion of the 3 point front bucket seat belts. I've got the retractors and belts. I just need the buckles. Also wouldn't mind picking up a rear jump seat belt setup. Thanks

Hi All, I'm new to this! I need some advice or a simple answer to my question. I own a 2005 HDJ100 with 440 000km. My front diff is shot and I'm not going to put a brand new one in because I can't afford it! I've been search for the last 6 and have just found one from a 2003 model. Both models...

$350

$200

Tag says October of 1970 from what I can see. $150 plus the ride.

Restored front seats out of my 80 FJ40. Sand blasted and POR-15, new foam where needed (surprisingly not much), new Cruiser Corps upholstery. Free local pickup near Tampa, FL. Shipping will be expensive, No way to calculate until destination is known. Thanks for looking.

Ok, relative 100 LC newbie here...I am currently working on baselining my new to me 2006 LC. It currently has OME suspension with heavy rear springs, SPC Arms, Slee front diff drop, Trail Tailor extended links, and the Delta VS panhard bar bracket. I have replaced the upper ball joints in the...

Looking for advice on which light/regular duty springs to put up front to maintain both stock ride height and AS MUCH of the stock ride quality that I can. They’ll be wrapped around Bilstein 4600s. OEM is not in the budget. I’ve googled a ton and can’t find anything that doesn’t lift, or...

Wasting time annotating my FSM, at the close of my overdue front axle service, and found this: (from the brake section, BR-18) (from the axle section, SA-10) So, what am I missing? Are these two torque values for the same bolt? The first image in the first illustration and the second image...

Hi all I have a 95 GXL Rugby World Cup Edition 80, and over the weekend I removed a damaged alloy bullbar and installed a stock front bumper. The bumper’s width is noticeably less than the vehicle’s width with the flares. Do the stock bumpers have adjustability with the side ends? I don’t...

No rust, some minor damage to lower lip $50 plus shipping