front

Thanks

Looking to install front and rear lockers on my 96.. preferably a complete set . Located in SoCal.

Figured I’d jump on here to see what y’all think. Gonna be a big one. I have a few things. First off. My 80 is on a 3 inch doninsons lift on 34 inch ridge grapps. I Noticed today when I have my 80 locked in front and rear and in 4 low… when I roll forward and switch between full lock left...

FJ40 grille and front bib. Fantastic patina with no penetrating rust or significant damage. Currently a wall hanger in my grill shack. Located in sw colorado. $500 + the ride Text is best 720-975-3767

I’m thinking about welding my front differential . I’m 17 so any kind of aftermarket locker is out of the spend most my time in the snow.

I need some advice before I fit new hubs... I am re-building my front end, swivel hub bearings etc and decided to replace the front hubs too as I could see a pronounced groove where the seal sits at the back of the hub. Then though stuffit, I fit new rotors too. OnlineAutoParts are super good to...

Nice set of front bucket seats with headrest. They have been stored indoors, so very little in the way of rust on the frames. $650. Shipping, if necessary, out of Jackson, TN, 38305.

I’ve been working on a regear to 4.88s I noticed some pitting on my spider gears and just wanted to check with someone who is more experienced with these. I’m only asking because I’m having a hard time finding/getting the replacements. I attached photos of the spider gears, let me know what...

Full set of control arms for an 80 series. I bought an extra set to install new bushings so I didn't have any downtime. Includes fronts with blue caster bushings for 2.5 lift, 2 rear upper, 2 rear lower, panhard rear and front. The arms all have oem older bushings. Also selling 2 front fox...

Seeing if anyone has one laying around. Going in 96' lx450. I'm over in west side of Michigan LP... Not paying stupid prices..;). Let me know...thank ya.

Greetings all. I need some help identifying and fixing a peculiar noise with my 1977 FJ40. I'll try to provide as many details as possible. 1. When driving in 2wd with the front hubs locked or unlocked there is no discernable unusual noise coming from the front drivetrain. This is consistent...

WTB - OEM grey front Seat bottom- in good condition - no rips or tears.

I’m looking to buy a 4PlusProducts front bumper for a 82 FJ 60 .

Nice older set, got a couple scratches. Good for daily driver or patina. $50 shipped Cheers, KevO

Cautionary note: you can bend these things with a big hammer. [EDIT] - Figuring out if I need to tear it all out and start over, including the diff. Opinions vary as you will see below. Short version of learning is that you should most likely never need to hammer the axle home and that you...

I'm swapping a disc brake front axle into my FJ45 and need new ubolts. Anyone have a set of 4 they're not needing? Thank you, Mike

My 84 has grease on the front hub. Is this normal or does it imply something needs repair? Attached is a picture.

Needing a single acorn hubcap, front with hole for hub. Useable condition for a patina restoration. Pic for reference. Thanks

So, I haven't been able to find much on anything to beef up the front other than to throw a solid axle on. Is there any content or anything floating around in regards to: - Front Diff Swap from another Toyota bigger than 8" - Spindle gussets - I don't really see anything out there - has anyone...

I have a new in box kit from LCP. I ran Timbren bumps up front that weren’t compatible with the kit. $100 plus shipping. https://sites.google.com/site/landcruiserproducts/sway-bar-disconnects