engine

Hey All, I just scooped up a '95 80 series this weekend out of Kentucky! The goal for this truck is to make it my daily in year when the lease is up on my Taco. Here's the details for the truck: 1995 FZJ80 - Moonglow Pearl 142,000mi low rust needs some fixin' So for step 1, I have to fix...

I had an old post that contained this, but other things as well (which are now resolved.) So, 1976 FJ40. Lights work. Start the engine and the headlights turn off (running side lights stay on). How in the world would that be happening? I've got a headlight switch replacement on the way...

Howdy all! Weather is getting cool here, and winter will soon be upon us. We get below freezing temperatures here and consistently in the 30s during winter. Is there a particular engine heater recommended for diesels like the H engine? I was looking at the Kat's Engine Heaters that heat up...

I have 2 batteries connected parallel for a 12 volt set up. I am told my batteries are bad. Since I need to replace them, what is the proper battery specifications for a 12th engine? Thank you

New owner of a 1995 Prado KZJ78W (Don’t know much about Cruisers) Question about a dim check engine light (can’t see during the day but at night it’s on and dim) upon ignition cycling the light is bright (how it should be if there was a engine problem) but after ignition it goes super dim. I...

Pulled this 1FZ-FE out of a 94 with an engine knock at 150k. PO blew a HG and had the engine rebuilt (poorly). Engine knock is occuring in cylinder 6 with very mild bearing wear but within OEM Spec. All other bearings checked out ok. I didn't spend a lot of time troubleshooting as I replaced...

Hello guys 2 days ago i crashed my beloved HZJ78 in a van on a extreme slippery road. No one got injured but the van is totaled and my land cruiser has some heavy deformation in the frame and the body. The body also has some rust so i think it is the time to buy a new vehicle. My land cruiser...

Good day one and all; I have a 1978 BJ40 with the 'B' engine which is shot. Has anyone been able to drop anything other then another 'B' without running into a lot of problems? Just wondering. Thanks, Don

It's this one-- Engine Skid Plate | 03-09 4Runner / GX 470 / FJ Cruiser - RCI Off Road - https://rcimetalworks.com/product/03-09-4runner-front-skid-plate/ 3/16 Steel, Black Powder Coat, Fairly new, No dings- $200

I've been seeing several places that will tune Toyotas including Land Cruisers. Has anyone had this done? The tuning is supposed to really improve the performance. I have a friend who had his Tacoma tuned and said the performance increase was dramatic.

I have an automatic transmission from my 1988 FJ62 with transfer case. Thee transmission got overheated so I swapped it with a replacement. Transfer case is solid. Make offer/any offer. Not willing to ship located in Long Beach Ca.

Hi, Looking for this wire harness, highlighted in the photo below. It runs from the fuse panel to the A/C, Headlights, Temperature Sensor, Horns, and Fans. According to Partsouq, it works for vehicles manufactured from 7/1999 - 5/2000, but I suspect there's good commonality between the...

Looking to replace my Weber Carb with an OEM. I've got a 72' 40 with an "upgraded" 2F engine date stamped 12/78. Looking for a stock carb for this engine. Ideally, it'd be re0built and ready to go. But, if I can't find one, I'd be willing to buy a core from someone and have it re-built. If...

I have been chasing a white rabbit for a long time dealing with my starter on my 1996 FZJ80, and I need a fresh set of "eyes". The problem I am getting is when turning the key, nothing happens. You can tell power is being drawn from the dimming of lights, but no starter action. In the past, I...

Rebuilt OEM FJ40 Carburetor by Mark from Mark’s Offroad in Burbank. Has around 500 miles on it since the rebuild. Switching to a 2F engine. $450 shipped within continental USA or $420 local pickup. Came off a November 1970 FJ40.

Recon 2H head for sale, parting out my engine from my HJ47. will post more parts as I take them off, (ip,lines,injectors, cranckshaft,etc.) Located in San Diego Ca, ship on your dime, heavy. $500.00

Manifold from I believe an F engine. $150 plus the ride.

I have a complete F engine, transmission, transfer case out of a 72 F40 for sale. It ran when removed and has been sitting for a bit. It is complete with all manifolds, carb&air cleaner, valve cover, flywheel & bell housing, water pump & all pulleys, alternator, motor mounts and more. It was...

I removed the dash to do evaporator and heater core. After I reconnected everything the engine won't turn over. Any suggestions?

We have a 94 FZJ80 with a bad motor and a used motor out of a 97 based on what the VIN tells me, it came with the truck. I have seen some other threads saying there are differences between the two. The 97 motor we are planning on putting in does not have any accessories or intake on it, I was...