For Sale 1FZ-FE Short Block

[JoeCova]

Vehicle Model

1. 80 Series

Pulled this 1FZ-FE out of a 94 with an engine knock at 150k.

PO blew a HG and had the engine rebuilt (poorly). Engine knock is occuring in cylinder 6 with very mild bearing wear but within OEM Spec. All other bearings checked out ok. I didn't spend a lot of time troubleshooting as I replaced with new factory short block.

Asking $300, located in Colorado Springs.

 

[Fj80oregon]

To bad you’re not closer I would buy this today!! Keep that thing lubed up so it doesn’t rust!!

 

[dannyscmseries80]

Pulled this 1FZ-FE out of a 94 with an engine knock at 150k.

PO blew a HG and had the engine rebuilt (poorly). Engine knock is occuring in cylinder 6 with very mild bearing wear but within OEM Spec. All other bearings checked out ok. I didn't spend a lot of time troubleshooting as I replaced with new factory short block.

Asking $300, located in Colorado Springs.

View attachment 3443069View attachment 3443070View attachment 3443071

Joe where did you buy your new short block ?? I am looking for a complete engine for my 1994 LC. Thanks !

 

[JoeCova]

Joe where did you buy your new short block ?? I am looking for a complete engine for my 1994 LC. Thanks !

Ordered it through my local Toyota dealer. Took a couple weeks and was about $3500 after discounts.

 

[RiverCityDave]

Ordered it through my local Toyota dealer. Took a couple weeks and was about $3500 after discounts.

Money well spent. If I were sticking with the 1FZ platform (and I would be if I didn't have a 94), this is precisely what I'd do.

 

[JoeCova]

Bump, I need space for more stuff.

 

[SteveL]

Bump, I need space for more stuff.

I did the same, new short block from Toyota. Happy with it.