carb

I just rebuilt a 1976 2F and the machine shop showed me my intake had been welded with a tasty weld bead right in sight (no leaks) but with an expensive fresh rebuild I want my Cruiser to breath and avoid any ashtma issues. Also, my exhaust heat riser flapper (technical term) leaks and I am...

9/72-9/73 bellcrank carb throttle linkage assembly. $115.00 shipped.

Having hard time finding a 1966 Carb kit for a fj40 single barrel carb oem

Looking for carb hat. Please PM me with proposed price. Thanks

Good morning all, I am hoping to track down someone with a 1HD-FT powered HDJ81 in an emissions compliance area of Colorado (front range). I went for inspection at the emissions technical center in Denver this morning and was told that beginning in 1997, the HDJ81 had catalytic converters...

1987, Carb ID 21100-61142. I am rebuilding this carb (my first time) since I bought the and wanted to tune it up. I have meticulously laid out each part in order of how I have taken it apart. Primary Venturi, then Secondary, in that order was how it was removed and laid out, and that is how I...

Any ideas? The cruiser is a 74 fj43. Apologies for the potato photo

If somebody has an extra floating around and can throw it in an envelope I’m willing to compensate :) pic to show the exact linkage courtesy of SOR. Zip code 99669. Thanks

Trying to properly desmog my 86 FJ60 2F which was half a$$ desmogged by a previous owner. Having trouble sourcing a rebuilt aisen carb and recurved distributor. Any ideas?

Hey all, On my 69 FJ55, I noticed yesterday the fuel pump was leaking. Quite a bit, actually. So I'm about to order a new one from TEQ and had a thought. Does anyone know what the pressure output of the OEM pump is? On my 1980 4x4 Hilux, it has the 20R with the Weber 32/36 and ran terrible plus...

First sample of reproduction done. Turned out well. A few minor blemishes that can easily be rectified. Trial test fitting over the next week. Hopefully I can get the Gasket reproduced also?

Hi all, been a while since I posted. Moved overseas for a few years and didn't want to risk putting my TLC on boat. The wagon sat in a climate controlled warehouse, and I drove it all last spring and put it away for the summer (Texas heat + no AC). I'm having an issue with idle and mixture...

Giving up on 1F carb rebuild, won't stop leaking. Got a 2F carb but need throttle bracket. Saw Mark's has them, but 1 doesn't meet his minimum order.

to go on my ‘66 Fj40 - thanks

I screwed up. Rebuilding my 83 FJ40 carb and didn't record the numbers on the long slow jets. One is #65 & other is #90. Need to know which is Primary and which is Secondary. Don't know if it matters but I'm at 5000' elevation. Thanks, Jim

Price drop! FJ40/FJ60 oem carburetor. Pulled from a running 82 FJ60 with a 2f engine. $200 or trade for a rust free fj60 gas tank Fj60 Pair of Rear mud flaps $100 FJ40 manual steering box. US spec LHD. Works well, but leaks. Will need seal and o-rings. $100 Located in sw colorado Text...

I have a bad habit of buying parts and asking questions later. Now it’s time to clean the garage out a bit. Located near Boone, NC Split case and transmission from a very early FJ60 (1980 - maybe 1981?). This case will not work with the later h42s or h55s. I think it’s similar to what was in...

After repairing the exhaust/intake heat valve I was installing the carburetor and noticed the insulator was pretty rough looking. Does anyone know the correct insulator for a 1962 FJ40 with a stock carburetor? Robert

Hi all, I'm about to rebuild my original carb in my 1980 and I've got a lot of rust going on around the base and along the block/manifold. Any ideas on what could cause this type of corrosion and how to avoid that in the future? My air intake manifold rail had 3 out of the 5 fittings...

Looking to replace my Weber Carb with an OEM. I've got a 72' 40 with an "upgraded" 2F engine date stamped 12/78. Looking for a stock carb for this engine. Ideally, it'd be re0built and ready to go. But, if I can't find one, I'd be willing to buy a core from someone and have it re-built. If...