carb

Hi guys, wondering if you can help me identify what this noise is that I am hearing when I shut off my 1985 fj60. I recently had a brake job done and after driving home I noticed the carb cooling fan is working for the first time under my ownership. Only thing is there is a pretty noticeable...

D40 Carb I do not need. $80 plus shipping

I have a 1978 FJ40 which was imported from Columbia and has carb issues. The existing carb is an Aisan, it looks like it may be the original, has the 'rod' linkage and has a vacuum operated choke breaker. I have read quite a few discussions on this site about the pro's and con's of Aisan...

Manifold not included! Downey air cleaner and holley carburetor As per photos $250.00 shipped lower 48 Thanks

Complete smog set up from a 1984 fj60. All worked when removed. $300 includes shipping within lower 48 states.

Believe this is year specific? to a 1973. 100$ shipped to lower 48

Hey guys - finally went ahead a did a “rebuild” on my 2f carb. The float valve was sticking amongst other things. I put carb back on and similar symptoms - idle fuel pulling through Venturi. I read in the forum to blow out the idle circuit, likely blocked (with compressed air and carb cleaner)...

Hello I recently purchased a 2f out of 1987 fj60 with newer carb and smog stuff. I also have a f carb from original engine 1970 that will probley need a rebuild. Should I D smog newer carb but also have figure out going from cable 1970 pedal to mechanical carb.

Hey guys My carb in leaking bad even anfter rebuild and I need a loaner/ rental/purchasable carb that works to get me until I can rebuild my stock one. It’s my only rig and I’m out of time with ship space. Is there anyone in the mountain west selling one or better yet renting jt out? I’ve got an...

Hey guys, At the last line of defense here with firing this thing up. Rebuilt motor and whole project coming to this point. Carb was leaking upon initial firing yesterday, snd I think had a vacuum leak as well. so I rebuilt the carburetor again and it’s still leaking. Vacuum leak is resolved...

So this seems to be a common issue. I've read about 10 different posts on it, and affects 2F's as well. It seems some great idea's from Okie rebuild, to replacing seals, or doubling up on seals or polishing bits. BUT I cant find a single thread that end's in "Well that fixed it!" Issue, Carb...

Read a few different threads about jet sizing but it seems to differ for year models. I have an early Aisan F carb that l am running on my 2F in my 71 FJ40. I have removed the old jets and found the primary main jet 112 Secondary main jet 200 Slow jets both 50 (saw 0.85mm recommended) Power...

1974 1.5f motor carb with all plumbing and air filter houseing and distributor., $300. No shipping, Kelly 661-947-1514

Hello everyone, I've owned my FJ60 for a couple of months now and have been getting my hands pretty dirty adding and replacing a myriad of components. I took my rig to a local Landcruiser shop near me for a vehicle inspection to get the lay low on what is, and isn't, working properly. One of...

What size carb jets should be in an oem carburetor, for 2f engine operating at sea level?

I am sure this has been discussed - I apologize if bringing up covered topic- she will start and turn over with a blast of starter fluid. Then cuts off- I was able to draw fresh gas from tank to newly installed fuel pump but cannot get the bowl to fill- a couple of caps of HEET in the tank with...

In search of new spring for carb Stopper as shown in the two images below. #9 from the FSM and circled in the parts diagram. The OEM part # is 21864-26020 but it’s NLA.

In our 80 4wd pickup, brother swapped over a new aisin carb and it was running great, he had to reuse fuel cutoff solinoid Which died a week later. All our old carbs are 22r which is a different solinoid (4 wire plug) I'm trying to source a new 20r replacement, the carb is brand new Is...

Need some help on this one and looked at every archived topic around Cooling Fan Sensor issues. I have a 1981 US Spec FJ40 for reference that is de-smogged but retains the cooling fan and relay/ecu and original crusty sensor. I have reached out to a couple of my "go-tos" like @GA Architect ...

Hey all I know there are members who do outstanding jobs of rebuilding and selling FJ40 2F carbs. I’ve been searching in mud and can’t find their contact info or websites. I’ve tried to send messages. Is there an existing resource list already? If not..can someone please post a contact list...