are

  1. CenTXFJ60

    For Sale  Custom/aftermarket Bumpers in San Antonio are

    i had a post on this a while back but have no idea where it went. $500 for the pair or $300 per each. Front is aftermarket and rear is custom out of austin. These are tough as nails as they protected all the appropriate areas when the 60 they were on rolled several times. Unfortunately we can't...
  2. HemiAlex

    My rear seatbelts are less than functional: HELP

    I'm sick of the seat belts refusing to extend normally. They barely work and everytime I go from the seat folded flat to upright, it takes a few minutes of fighting to make them work again. I'd like shoulder belts, that would make everyone feel warmer and fuzzier...but at this point I wouldn't...
  3. torpedo51

    why are both of my rear windows topping out with a 10mm gap?

    I bought an FJ62 today, sight unseen, on auction. Both of the rear windows appear to have been raised, leaving a 10mm open gap. Then, the previous owner put duct tape over the gap to keep the wind out. Both sides. Looking for some opinions on why both sides have the identical problem. Did...
  4. BullElk

    Are all brands of 275 70 18 tires same diameter ???

    Do brands differ in actual diameter size. if I had happen to have a choice I would get the larger even though I know it wouldn't be much difference. Just curious. Thanks
  5. KYLandy

    Towing a 2006 LC: What are my options?

    From everything I have read, the LC cannot be flat-towed so I have to trailer it. Anyone else towed their LC without a trailer? Can you disconnect the rear drive shaft and tow it using a dolly? I am looking to take my LC with me on a Colorado trip in May with my truck and truck camper. I have a...
  6. rc51kid

    Are our trucks all wire for power seats?

    Simple question. I have a 94 that came with manual seats. I am looking to do a seat swap. My preference is for non power seats but most new seats in good shape are power. Do our trucks all have 12v power already wired the ends under the seats?
  7. crawlin cruiser

    Things are good...

    Something I owned for 6 years and sold last may has come home. I couldn't be happier
  8. blue44

    LS3 Erod..how are 37s for DD?

    So our little 40 has bounced around several cruiser shops and has landed w trollhole. Lots of headaches w 2F rebuilds, so we opted for a crate GM V8. This started the domino effect that led to Atlas case, NV4500, Saginaw, SOA, and 99% sure we'll go w Dynatrac axles cut to 60" WMS. Never had this...
  9. M

    My Birfs are phucked.

    How much should I expect a shop to charge for labor to replace both?
  10. stock

    Installers of Aussie lockers in Philadelphia are

    Hi All, I'm going to get an Aussie for the rear of my 1991 80, my first modification, and am trying to decide if I'm doing it myself or farming it out. Any installers in the area you recommend? I'm going to get some quotes and decide. I'm in Philadelphia.
  11. Kabanstva

    What are some "go to" shops around the US for doing work on the 100 series?

    I come from a Supra/Lexus SC300 background and know there are a good amount of shops around the country that are synonymous with those chassis. They can pretty much do any kind of build/tune etc. without me questioning if they know what they're doing (Sound Performance/Real Street/Powerhouse...
  12. P

    FJ-40 on the docks in Honolulu - can anyone tell where these licence plates are from?

    I park my daily driver near the roll-on/roll-off pier (and military vehicle shipping contractor’s yard) on the Honolulu waterfront. I’ve seen a few unusual cruisers (FJ-25, FJ-45, other FJ-40s) arrive in the islands in recent years. The FJ-40 in the photo is not exactly a show car… but it has...
  13. jmphilion

    Help - security sensor, the horn and lights are on

    Hi! Its just going on and on.. How to reset the security system? The detector is on and horn plus parking lights are on.. Wtf.. Its parked in my driveway No windows broken, What to do? Thanks
  14. Blasst

    anyone know what arb storage systems are made from???

    Just brainstorming.....planning my build. Wondering what arb uses. thanks....
  15. Beej

    What are stock 97 tan seats worth?

    Hey folks, I see a bunch of how much is worth on the front page here. Thoughts I'd throw my hat in the ring although not strictly tech. I've got a pair of front seats with the leather in good condition; no hint of tearing; some tertiary wear; otherwise clean . All power works. I'm swapping...
  16. E

    OEM skid plates...how good are they?

    Do they hold up well or is that something I should replace before heading to Moab?
  17. Varty Yo

    What are these?

    Found these along the driver seat by the heater. They go together but i have no idea what they are for. I dont wanna blow up the truck by hooking them up.... haha
  18. ariff

    Annoying buzzing when head lights are on video

    My Son and I finally got to take the cruiser on her maiden voyage tonight.. After a few months of working on it and fixing all the things that go bad when a vehicle sits for a few years.. Anyhow we took it out at night to the car wash and noticed when you turn on the lights you get a very...
  19. sPaulp

    What's too many miles when looking at used 200?

    Hello all. So, I have been eyeballing some 200 cruisers and found an '08 with 137k miles, and in phenomenal shape. It spent it's first 6 years in Ohio, but then lived in Florida until now. The undercarriage looks good with some minor surface rust but very minor. Good maintenance history, and...
  20. riffman12

    Does anyone know what these unused plugs are in my engine bay?

    See pics below. This is by the passenger side firewall right by the OBDII diagnostic port It's part of a harness that goes through the firewall. There seems to be one female plug with 2 males that could plug into it. At the moment all 3 are unplugged. It's a 4 pin connector. Anyone know...
Back
Top Bottom