I was starting to highjack CND's thread with the LC200, so here's a new one. Kind of a continuation from my winching with Lithium thread, which concludes that winching with Lithium is somewhat new territory. At least when I set up my winch wiring, I made the leads long enough to reach both my...
The specs on my LC200 Alternator says it puts out 14.6 volts and can handle 150A.
I'm planning 300AH or 400AH Lifepo4 batteries (to power my fridge, induction cooker, air-fryer, charge my eScooter, etc etc.)
I've already got 600W solar and a 50A MPPT charger.
It seems kinda crazy to spend huge...
Hey guys, I’ve got an f motor I want to put a gm alternator on. I have it mounted with a 2f bracket.
What do I need to get pulleys to line up for belt ?
Thanks, Rick
HJ61 24V LHD
While I had a problem with my alternator which suddenly stopped charging, relying on certain other posts, I did not even look for the existence of the Charge Light Relay believing that it was non-existent on my vehicle. It was a huge mistake because after hours of testing and...
I'm using Coolerman's adaptor harness for installing an internally regulated alternator from a later vehicle into my '77. I had the alternator checked at the local Orileys to make sure it was charging.
I've triple-checked the tie-in of the adaptor harness to the factory harness. per...
Looking to upgrade the OEM alternator in my 67 FJ45 to get more Amps to drive the Warm 8274 winch I am installing. Research shows that the GM 10si “one wire” internally regulated alternator which produces 140-160 amps and will work with my FJ45. Anyone else using one, and if so notice a big...
Car: 2000 RHD LX 470 2UZFE A442F trans
The car has been driving fine since I bought it 6 months ago but theres this parasitic draw of 0.4ish amps which goes away with the "alt-s" fuse
it has led me to the alternator but switching alternator didn't change anything and the wires in between seem...
Hi guys! I have a diesel 200 series... it has 2 oem batterys connected in series. I have a trailer with 2 100amp batteries and I would like to charge them with the car, which would be the best alternative? I've read that an isolator doesn´t work properly with these alternators... but I have my...
I replaced my alternator with a spare yesterday while trying to figure out some other problems (my other recent post about blinkers causing the edic to shut the engine down details this) but I thought post a sep post about this. This didn’t fix my shut down problems either.
after the alternator...
Original alternator from my old Fj60. Spins freely but will need to have the voltage regulator replaced. I went ahead and bought new Toyota brushes, springs, and a regulator with the plan of rebuilding it. One of the long phillips head screws has had the head destroyed, I have a replacement I'll...
Hi All, 2011 LX570. Short version is my battery is currently dead dead. I can jump it, but when i take the battery pack off, it dies shortly thereafter. I feel like all the symptoms are that of a failing alternator, but the symptoms of an alternator issue coincided with me trying to tap into a...
I've been super careful and made it through a valve cover gasket R&R, intake R&R, Plenum R&R, IAC repairs, radiator hose replacements, belt swaps, water pump R&R, etc. and thought I'd succeeded in avoiding the fate of my past 80's and didn't break the dang nipple on the radiator. Then last night...
So for the longest time I've had issues with the dash lights blinking while driving
I suspect it's the alt and not the plug simply based on mileage
I'd read that a tercel alternator fits. But when I bought one, mines different.
Mine was slightly larger and had an oval plug. From reading...
Hello Gang,
I recently purchased a new alternator through Cruiserparts.net.
I had them send me a used greeen plug and I need to know how to wire it!
Same gauge same colors easy, what to do with the larger white wire left over? The last guy had a hitachi alternator and had different plug set up...
Does anyone know, or have a photo of the interior fuse panel, with what goes where - as far as what fuse is for what? How about the fuse for the gauges/alternator? How many amps should this fuse (fuses?) be???
I have finally gone through the parts hanging out in my garage.
For sale here are a few parts from my old 3b powered FJ60, that has moved on to greener pastures.
7/23/23 Pending- 24V alternator $25
7/23/23 Pending x4- 8 Nippon Denso injectors pn: 237010E (see photos) $200 for all of them or...
My alternator has been questionable since I acquired this 40.
Hate to replace oem with a crap aftermarket part. What's available that's recommended?
Anyone replaced one recently?
Newbie here: I have searched the forums and cannot really find anything similar so I figured I would post here.
Last week I noticed that my voltage gauge would dip slightly at lights and stop signs, occasionally going as low as 2/3 before rising back to just below the 3/4 mark. my first...
Hey guys, time-sensitive issue as I may need to return this thing ASAP.
Got a Nations 270XP alternator for the Lexus GX470. Believe it is built by DC Power and Nations is actually just marking it up $40 or so (awesome).
Their alternator omits the one side mounting bolt hole and just has the...