Malleus
Far west of Siegen
I use that as a low level temp gauge...when it makes noise, I know it's below 55° outside.
What Did You Do with Your 80 This Weekend? (77 Viewers)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Just tested it on the highway the thing PULLS! It’s violent and wants to eat.
There is no replacement for displacement ladies and gentlemen.
There is no replacement for displacement ladies and gentlemen.
Idaho Savage
GOLD Star
Holy smokes.
That’s so wild. I don’t know the 2jz motor, but is that the closest cousin? Thanks for sharing this.
KPH speedo. ~38% faster to 100....
Not closest cousin, bigger brother!That’s so wild. I don’t know the 2jz motor, but is that the closest cousin? Thanks for sharing this.
Need a draggy GPS to test 0-60mph, quarter mile and 100-200km.
The factory speedometer is off since I’m running 34.5 inch tires so wouldn’t rely on that.
This weekend I was able to finish putting heat shielding over the cats, exhaust and transmission tunnel. Also replaced metal lines to the rear heater and put the rehabbed exhaust heat shielding back in.
Holy Crap! That’s awesome.
Malleus
Far west of Siegen
I thought that piping was long gone...now there's something else I have to buy! But, unlike everything else I have to buy, I actually need this.
New heat shields, too?
I was going to do that but I am afraid that I would increase the temperature of the transmission.
No, I just cleaned up rust and grim and painted the heat shields.
Pulled off a 1HD-FT head to re-ring the block…. Blow-by city.
Quick and simple job while also doing some PM and other things like hoses, ACSD delete, gaskets, seals, timing bits, cooling system overhaul and turbo rebuild…
Quick and simple job while also doing some PM and other things like hoses, ACSD delete, gaskets, seals, timing bits, cooling system overhaul and turbo rebuild…
Just finished the 50 mile break-in on the new engine with a new Magnuson supercharger. So far, loving it!! Taking it easy for the next 500 miles. The front and rear was restored, along with other restoration work and updates. All OEM with a few exceptions. Can't wait to get her out on the trails.
Looks really clean ! Nice attention to detail
During the weekend I removed my old, crappy, homemade drawers.
So today I decided to cut a hole in my tailgate
Then I covered it up with a Huracan Fabrication tail gate lid storage thingy
After finishing up, I realized I goofed and didnt remove a piece of the original tailgate reinforcement, so it does cut a bit into the space.
But this is a problem for future me!
So today I decided to cut a hole in my tailgate
Then I covered it up with a Huracan Fabrication tail gate lid storage thingy
After finishing up, I realized I goofed and didnt remove a piece of the original tailgate reinforcement, so it does cut a bit into the space.
But this is a problem for future me!
kelly saad
Supporting Vendor
Over the last few weekends, on my days off. Sandblasted and painted the back 2/3 of the frame. Mounted the replacement body onto the frame and firewall.
kelly saad
Supporting Vendor
Sandblasted my calipers, high temp color matched epoxy caliper paint and then rebuilt the calipers.
kelly saad
Supporting Vendor
All welded back together, other than the floor seam. Seam sealer on all the welds and seams. Off to my friends house for the mechanical work.
