- Thread starter
- #1,401
Did you fab a stool to reach the work surface?
Pretty quiet in here... what are you working on?
- Thread starter Stumpalama
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
So I may need to build a platform to reach at full deck height. I wanted to make sure I had enough room to press rear axle bearings.
- Thread starter
- #1,403
Replaced the broken caliper...
Used red locktite this time.
Used red locktite this time.
Knock sensor wire broke away from its connector; hence I'm going to try my hand at splicing a new connector into the main engine wiring harness...sounds easy enough...
- Thread starter
- #1,405
Paging @emorth .. he's even in your neighborhood.
Bending plate to make bumpers 
Go on...Bending plate to make bumpers
Bending plate to make bumpers
Teaser!!!
- Thread starter
- #1,410
What length of 1/8 can you bend?
Mine only has a 24" opening but the frame is not heavy enough to Suport the pressure.
- Thread starter
- #1,412
Ha! I meant to ask @OTRAMM
Theoretically it'll do 48". I've still got to build the press brake for it though.
Packing...
Wahhh. Wahhh. Wahhhhhhhhh
Wahhh. Wahhh. Wahhhhhhhhh
Hey, that's my 40 in the bay behind the press!!!!
Got some of Uwharrie off the truck since the photographer is coming Monday to take pictures of the house.
- Joined
- Aug 4, 2008
- Threads
- 140
- Messages
- 3,478
- Location
- Commonwealth of N.VA
- Website
- www.capitallandcruiserclub.org
It's time to replace the steering rack on my 3rd gen 4runner. Should I go Toyota or does one of the reman units from somewhere work well enough? I'm waiting on the price for the yota parts
All the remans I've ever seen have been junk. Most don't even work right out of the box. I'd go Toyota.