wiring harness

Saved these harness sections from under the dash of a recently stripped 1986 FJ60. Good shape one has the fuse box the other has different relays and devices. price $30 either one shipped in the CONUS. $50 shipped for both. Best to email me shmukter@pa.metrocast.net

I am installing a new wiring harness in my 71 FJ40. I need to know if I can install a fuse able link in-between the voltage regulator and the fuse box. The + feed comes from the voltage regulator directly into the fuse box (different from the original factory harness). I had an issue where my...

I have a full wiring harness off a 1986 FJ60. $175 plus $25 to ship anywhere in the lower 48 via UPS Ground PM me for more info Quite a few pics here

I have a brand new wiring harness that I no longer am going to use. I purchased it for an engine swap project and the guy backed out. It is a stand alone harness for a Gen IV/ 6L80E or 6L90E trans. This will fit any of the 2007 to current truck engines with or without active fuel managment and...

Recently, I purchased a 2008 LandCruiser for the purpose of towing our family airstream. It did not come with a wiring harness, so I purchased the hopkins plug in harness for the factory tow package. It has a 7 way and a 4 flat as well. Install was simple enough, few bolts and two plugs that go...

Looking for an OEM rear harness to fit a '77 FJ40.

this is the complete front and rear wiring harness. Lots of the end connectors need to be replaced. It's in good condition overall. After having to replace sections of mine recently I understand the need for a complete harness so I took the time to remove it. $120 plus ship

I have a 5.0 V8 EFI from a 1993 Thunderbird with complete running wiring harness and computer. It also comes with a NP435. Includes alternator, fan, complete air intake. Everything you need to plug and play into your truck. Mileage is unknown on the engine and transmission. It starts up and...

I found a issue with my 100 last night. There is a hole worn in the drivers side wiring harness back where the previous owner had installed an inverter.(in the Subwoofer Space) I am really surprised I haven't seen any issues up to now. Only discovered it because I was adding some stuff and...

The following posts are to document the 1FZ-FE US market 80 series 1995-1997 OBD2 main engine wiring harness connectors. While this is not exhaustive in the sense that it covers every single connector, it does cover about 95% of them. The remaining 5% or so are not sourceable outside of the...

Howdy all, Doing some troubleshooting of why my trailer light harness isn't working, I came across the weirdest thing. I found whoever put in the wires cut about 1/4 inch of wire from the original trailer wire harness, P/N 00526-00930, for what appears to be the left hand turn signal wire. I'm...

Anyone have any experience fixing a melted / corroded wiring harness connector? I was chasing down some trouble with my rear taillights on my FJ60 and fixed some problems then found more. The blue connector from the main harness to the rear harness has a corroded / melted pin and I need to...

When it comes to repairing a wiring harness, would you prefer to: 1. Splice in a short length of new wire by soldering. If the problem is at the connector, crimp new pins and new connector. Use heat shrink tubing to seal it up. 2. Replace the entire length of damaged wire, crimp on new pins, and...

Looking for a full set of 2UZ engine wiring harness plugs... or maybe a full harness. mark

I'm looking for all of the plugs that connect to a 2UZ engine. Is there a source for these? mark

I pulled off my steering column cover to replace my ignition cylinder and noticed one of the soldered wire had broken loose. Can I solder it back on without buring the plug or am I looking at a replacement?

My 1968 needs a wiring harness. I am only interested in an OEM one. Does not have to be perfect.

We have a 95 that has serious rear harness corrosion and shorting. I found the problem area the other night. i have some parts of a 92 harness and am wondering if the two are the same or even compatible for swapping. Pics are here: more weird electrical gremlins-95 fzj80 I need to DD the...

Looking for a complete wiring harness. Painless, Kwik, or Coolerman (front, rear, or both) for a 74 FJ40 with a 1.5F

Looking for a complete wiring harness (cowl, taillight, wiper...) for a 63-67 FJ40 w/heater. Something I can work with to rebuild or clean up. TIA!