Started with a search, but not finding an answer to my specific issue. The GX has plenty of heat, but it only wants to come out of the vents above 2500/3000 rpm. As soon as I drop below that, it goes ice cold. Is this a door motor issue? A circuit board issue? Has anyone seen this before...
I kind of doubt anyone does but looking for install ideas. All I can find is one Russian guy with a write up in russian
Seems straightforward enough. Hack in the pump. Tee the fuel line into the fuel line, I was going to tap the return line, run a power wire to the fan. I was going to use the...
I have a nice 76 BJ40 that came from Costa Rica with two A/C units. They are installed under the dash next to one another but one of the units (passenger knee area) was converted to a heater. Winters are very mild in So TX , typically never dipping below 32 degrees and only a few days when it...
I began the process of rebuilding my heater box, and it wasn't until I began putting it back together that I realized I was missing a part. Im missing the L-shaped Linkage that goes on the driver's side bottom front. Ive been advised that there may be different styles of this part. Seeing as...
Hi All,
I began rebuilding my heaterbox, and didnt realize unitll i started putting it back together that im missing a part. Im hoping someone has a suggestion as to where I can source one. I circled the missing part in blue.
Reduced! I have the following part available - FJ62 Center Console. The console top need to be repainted or refurbished. $50 plus the ride. Email me at overton@aol.com or PM me.
Hi,
I ran a quick search, came up with dick squat. When I turn on the climate control, it reeks of dog. While I like dags, I don’t like the smell in my car.
Any suggestions on how to remedy my FJ80’s ailment?
Hey guy's,
It is horrible for me to ask, but the search function on the forum could not help me, I found only things that are aside my problem. (Have to say, I am not at all good in English, so that doesn't help neither in tech talk..)
My front heater doesn't work. Blower works, rear...
I want to thank @GH1291 and another member (can't find the thread at the moment) for putting some helpful information about the wiring for the seat heaters on ih8mud.
This will be my overview of recovering the front leather seats in my wife's 2005 LX470 with about 250k on it. We ordered seat...
Heyyy ery body.
So I have a potential hook up for a batch of part number 87245-60420.
This is the heater hose that replaces the u-turn hose and fittings, which is used when bypassing the rear/floor heaters.
In the picture it is the red hose. It eliminates 3 hose clamps and leak points, and...
Has anyone sourced the foam necessary to restore a '73 FJ40 Heater. SOR has a kit for $26.
I searched through Ih8mud and didnt find anything. There has got to be a good source of foam, that does not cost $26.
Cleaned out the mouse nests in the front heater blower fan. Is there anything I should do to rebuild or lube the heater motor before I reinstall? The blower motor seems to work fine, but I see two screws that might or not take the motor apart and wondering if I should to pay some attention to...
Howdy all!
Weather is getting cool here, and winter will soon be upon us.
We get below freezing temperatures here and consistently in the 30s during winter.
Is there a particular engine heater recommended for diesels like the H engine?
I was looking at the Kat's Engine Heaters that heat up...
It's an old LX450 and we sure like it. We are LC forum people from way, way back. But after getting home from a month away, we found the glovebox and heater fan full of mouse nest . Looks like shredded brown cloth fiber insulation from somewhere in the car.
Darn, how did they get in? I...
Has anybody had a heater blower that runs then not? I can be driving along, and it just shuts off. I have replaced the blower, and removed the dash controls, cleaned inside the best I could. The buttons all have nice crisp snaps, between speeds, and redirecting air flow.
Blower off/on does...
This is an early Clamshell heater.
12V.
Runs and functions properly.
no cracks in the blower housing.
Used in early to mid 60’s Land Cruisers.
Hard to find.
Asking
$550.00 o.b.o.