exhaust

  1. C

    For Sale exhaust header for 1974 fj40

    I believe this came off a CA smogged vehicle. It had a plenum that helped with warming up the vehicle that has rusted out ( you can see just on the rights side of the exhaust mounting point on the 1st pic and just to the left on the back of the exhaust mounting point in the 2nd pic). I...
  2. Tom6156

    Exhaust for 2008-2016 land cruiser

    I'm looking for an aftermarket exhaust for my 2016 land cruiser. I am not having any luck. No one has built on for it yet that I know. Billy Boats (b&b) in Arizona will custom do one but they need a vehicle for 3-5 days to design one and I am too far away from there. Does anyone know of an...
  3. nmcbride89

    Exhaust "Pulsation"

    Does anyone know what's going on here? It was doing this for a few days, along with a high idle (1000 rpm in park, 750 when stopped in drive), but then it quit and idled perfectly for like two weeks. Now it's back, along with the high idle. I know that at least one O2 sensor is bad (checked...
  4. nmcbride89

    Wanted FJ62 Exhaust Downpipes

    The PO removed the cats and butchered the downpipes, so in order to install new O2 sensors and have a proper exhaust system put on, I need to find replacement downpipes. Exhaust shop said it would be cheaper for me to find replacements, rather than having them fabricate a set with the O2 bungs...
  5. AaKnight

    Wanted Exhaust Manifold Heat Shields

    Looking for a clean set of exhaust manifold heat shields for a 1FZ engine .... mine have rusted out bolt holes. shipped to Broken Arrow, OK 74014 thanks
  6. VFRMAN

    Finally Installed New Exhaust System

    I've had my truck for 12 years now and have probably needed a new muffler for about 8 of those years. I don't remember how many times it's actually broken and fallen off, only to be welded up again and tucked back in place. Anyway, after looking at every exhaust thread on MUD I sourced the...
  7. SB Closer

    EGR "J" Pipe to EGR Cooler Question

    I replaced the diamond gasket on the EGR j-pipe this weekend. I also put on a shiny new ferrule and cleaned up that end of the pipe. When reattaching the pipe to the cooler I noticed that the pipe seemed to have a bit of play and not be very tight. With the upper flange unbolted and the...
  8. alabamatoy

    For Sale Toyota 5VZ exhaust crossover pipe

    This is a NEW unused, uninstalled Toyota factory part. Toyota P/N is 1710662020. It can be found online for about $205 plus shipping. This part was shipped to me and received slightly damaged - there is dent in the heat shield on the upper passenger side which will not affect operation or...
  9. Manchild

    FJ60 priorities?

    Collective genius at IH8Mud, I recently bought my first Cruiser, an 83 FJ60, bone stock, doors and top removed, roll bar added, 150K miles. Found it on CL, flew out to IL, and drove it home to UT. The 1800 mile trip was awesome. It ran fine, pretty gutless, averaged 11 mpg, would get hot...
  10. G

    Borla Exhaust issue?

    Hey All- cant believe this is my first post- this site has been such an incredible resource- you guys are a bunch of Jedis! i have a 96 who is scratching at 200k (here she is after i photo shopped my suggestions for the new postal carrier trucks) and the exhaust went- so after a bit of...
  11. jesus888

    Help locating gasket for header...

    So, I have a FJ40 with a crate 350 (from 1999) installed under the hood, and some what looks to be "block hugger" headers mated to a flowmaster setup... I definitely have an exhaust leak on the drivers side, at the collector... but have NO IDEA where to get a new gasket for the collector... I...
  12. Prestonagray

    For Sale More 1987 parts-utah

    truck had 175k. All parts are assumed to be original. Power steering pump with res- $50 Misc smog lines and some valves still available- let me know what you need and we will work it out. Intake cover- $20 Intake and exhaust manifolds- $60 each Oil cooler- $50 2f short block - $100 4 speed...
  13. J

    FJ40 Header

    Would you be able to tell me if this is a Downey/Marks header and if so, what year FJ40 2F it would fit?
  14. Bogger

    Exhaust for 4.5L petrol

    Hey, What is the absolute best exhaust system for the petrol 80? In terms of; -loudest note -best performance Thanks
  15. my67nova

    1HZ-T exhaust

    Does anyone have pictures of a 3" turbo back exhaust in a 60? Can it go inside the frame rails?
  16. PinkLemon

    BJ70 Exhaust Routing

    I have a RHD BJ70 with factory 3B, the previous owner routed the exhaust out of the right of the vehicle right next to the driver's side window (given it's a RHD). It's very annoying, with the window open it's right in my freakin' ear... I'd like to get the exhaust routed the way it would have...
  17. DynoMax Exhaust

    ARCHIVE Our fall DynoMax muffler rebate is here!

    From now until October 31, 2015 save on our popular Ultra Flo Welded or VT drone-free mufflers. Click the link below for all the details and check with your favorite retailer on pricing. DynoMax® Performance Exhaust Promotions
Back
Top Bottom