Help locating gasket for header...

[jesus888]

So, I have a FJ40 with a crate 350 (from 1999) installed under the hood, and some what looks to be "block hugger" headers mated to a flowmaster setup...

I definitely have an exhaust leak on the drivers side, at the collector... but have NO IDEA where to get a new gasket for the collector... I don't know the company that made the headers, but I found a picture that is basically what I have... the key point is the 4 holes are NOT at the corners, they are in the center of the sides, just like in the picture...

Any idea where I can find the gaskets? Exhaust shop said they didn't know either

 

[Mace]

How bout..
COLLECTOR/CONNECTOR Flange Exhaust Gasket

These guys credit Street and Performance with a pic of the same header flange..

Techtips - LS SWAPS: Exhaust Systems Guide

 

[jesus888]

How bout..
COLLECTOR/CONNECTOR Flange Exhaust Gasket

You know, I saw that, but I am looking for exactly what to look for so I can decide on gasket material too... everywhere I read on the Chevy forums says Copper is the way to go...

 

[jesus888]

OK, I take that back... reading a little more about Remflex, and that just may be the ticket, thank you!

 

[Mace]

Perhaps, continue reading. Some people love them, others not so much..

However, it does not look like you have a ton of available options.

 

[shawnfj40]

You might call Summitt Racing. They sell every header out there.

 

[jesus888]

How bout..
COLLECTOR/CONNECTOR Flange Exhaust Gasket

These guys credit Street and Performance with a pic of the same header flange..

Techtips - LS SWAPS: Exhaust Systems Guide

I didn't see that Techtips link you provided... Thanks!!

 

[jesus888]

Put in my order... should arrive by Thursday... I'll post back to see if it's right!!

 

[Weber Sarge]

I would avoid 3-bolt header collector flanges if you can - the ball/socket type works a lot better and can take moving around a bit - as they all do eventually . Even with a braided stainless flex section the flat flanges will eventually leak....
Sarge