engine

SoCal NO SHIPPING! RUNS REALLY GOOD Cyl Head appears to be recently changed. This is in a 1991 FJ80. Odometer shows 131,000 but this is doubtful. Engine runs good. You are invited to test it yourself, bring a mechanic etc. ECU is extra. Engine sold without starter, alternator, Air Flow...

Hi. I wanted to pick the brains of the experts on here. Anyone that has rebuilt their 2F. I am thinking I want to freshen mine up. I haven't rebuilt a 2F before. I have rebuilt other engines, so I have some engine rebuilds under my belt. But I know that every engine can have its quirks. Where...

Location: Everett WA - 5.7L Vortec Fuel Injected Engine. Clean no know issues. Approximately 95,000 miles on it. - 4l60E Automatic Transmission. Recently rebuilt with less than 3,000 miles. - Brand new 19 spline Advanced Adapter that mates to stock FJ60 transfer case. The drivetrain is...

SoCal NO SHIPPING Please come to test the engine yourself, or send a mechanic. Runs good with 220,000 miles on it, valve job done a couple years ago. It is still in the car so you can test the engine. Compression check was run on 10/24/2017. All cylinders at 150 or higher, however the oil is...

Feeler -- 1996 Land Cruiser - 1FZ-FE motor + A343F transmission(Pretty sure it is the A343F) + parts for sale Engine issues – I believe the bearing somewhere in the bottom end. Transmission had no issues but it probably needs to be rebuild (I was going to do it but I am changing the direction...

SoCal Sensors, Oil Pan, Pulleys, AC brackets, Water pump, Starter, Oil level sensor, valve cover, wiring loom, alternator, distributor, injectors, exhaust manifolds, intake, EGR, etc etc. all from 1FZE engines. Also available are ECUs, please specify year and wire harness. Please include your...

I was searching for the engine photo base. It could be useful for the accurate restoration. Finally I would like to systemize some photos F engine. 6 cyl 135 hp 145 hp (end of 60) Engine Compartment ar 1970 1972/73 155hp 1973/74 155hp

I am selling a 2F Remanufactured (Reman) Long block: Powertrain Direct description, “TOYOTA 2F COMP ENGINE 81-87. 4230CC. WITH AIR. WITH POWER STEERING. 8 BOLTS TOTAL FOR INTAKE & EXHAUST”. Long story short, I purchased an 85 Landy out of Billings MT two years ago, the cruiser had about 2k...

Im finally coming to the end of my restoration project. The original starter worked good then all of a sudden would barely spin and the bolt that the positive from the battery cable would get red hot. So I replaced it with a napa starter and it worked great for about a week and is now doing the...

front and rear ends with spoke rims. $750 2f engine. Does run. Not original to FJ it came with. Carb is not toyo. $750 Trans/transfercase, column shift. $250 trans/transfercase set up for column shift. Original to FJ. $250

Cam 1975 FJ40. Block and head are coming home from the machine shop tomorrow. Bored, new cam bearings, valve job. I think I am second owner. Is this the original color? Is there a source of the paint?

2000 LC 293,xxx miles, on cold start ups there is a squelch that sounds like it's coming from driver side behind the firewall, very distinct inside the cabin, hard to locate in the engine bay over the engine noise. Some times it'll last about 30 seconds. Other times it'll go for a bout a mile...

My plans to convert my fj62 to a manual have changed... So after sourcing everything needed for the conversion, I now need to sell them! Donor 60 had a rusted frame 1985 FJ60. Running/driving when pulled. Here is what I have and would prefer to sell as complete set; Engine- complete with carb...

Ok, so I need a little help... I just purchased back my old 80 series (1995) from my son to help him out, as he transitions from the Army to college life. ($2000):beer: When it got here (last weekend), I heard horrible sounds coming from the engine... :bang: I took it over this morning to our...

Howdy, please see the attached pics below. The seller says it's a 2H from a 1980. Need expert's opinion here to confirm if it is indeed a 2H from 1980. Greatly appreciate in advance.

anyone know where I can get a already fabricated harness for a 3.0 to 3.4 engine swap harness? I heard someone might prewire them on hand? Thanks

Cranking my 2002 LX470 takes several seconds - maybe something like 4 seconds. Is this typical or symptomatic of some issue like fuel pump pressure, etc. ??? The cranking time is longer than either of my Camry, Isuzu, or Mercedes - those seem to almost instantly fire up.

SoCal All machined and ready to install. This was on a 1996 (fits all 1993-1997)FJ80, LX450 engines. The head was just installed and within 2000 miles the bottom end started to go. Another complete fresh engine was installed leaving this beautiful machined head already to install. This is...

I have just changed both Oxygen sensors on my 2004 LC with 92k after getting a check engine light. I am still getting a Check engine light P0051 (Bank2, sensor 1) after putting in new Denso sensors and disconnecting the battery. I don't have any dashboard lights out (as suggested as possible...

Ok, here we go... I have a 1997 FZJ80 that last year this time was a Victim of what I believe was a power surge caused by a lightning strike here in Florida. The ECM in question is part number 89661-5542. Here is the short version, I narrowed it down to a bad ECM. With help from the Service...