conversion

Happy holidays yall! Newcomer here and I've been following the popular conversion guide that I found through a thread here. https://lexusgxor.com/_media/general:nav_conversion_guide.pdf Kind of regretting that I took this on but I'm too deep in the weeds now and need to see it through. It's...

Hey, I was wondering if anyone has a bracket for sale for a gm style Saginaw steering pump. Thanks, jackson

When we bought Ms. Scarlet in 2017 the Clardy air installed in 1983 was dead. Replaced the compressor with a York and replaced the dryer. Everything else was good to go. Spent the extra money to stay with R12 for better cooling on the advise of the mechanic. Everything has been good until this...

I purchased this from a junkyard with plans to convert my Nav LX470 to a manual hvac control and double-din stereo. It includles the harness connectors and pigtails needed to convert your Nav harness. I never got around to doing the swap and have since sold my LX. I have no way of testing...

Hey guys. Still working on this 1974 FJ40, tying up loose ends before it leaves the state in a few days. Have to do an FJ60/2F "internally"-regulated alternator conversion to accommodate the FJ60 clutched water pump that I put in, and am running into some trouble with wiring. @Coolerman made me...

What you’re looking at here today is a Land Cruiser Prado conversion kit that (along with some labor) will transform your GX460 into a much more unique Land Cruiser Prado. This kit includes front fenders, hood, front and rear bumpers, headlights, taillights, front bumper fog lights...

I just replaced my sealed beam headlights with Holley LEDs in a all-four-low, all-four-high configuration (thread). There's some stuff that confused me about this whole thing that I want to write down here before I forget. I hope it helps somebody else, or, most likely, myself when I need to...

Electric to Manual Window conversion kit - Eliminate the anxiety of never knowing if your window is going to go up or not.......... (4) Manual window operators & bolt hardware Correct operator for each specific window (4) Door Cards - front passenger and rear passengers removed from a blue/grey...

Hi I have not posted but have been a reader for years. I have and fj 62 with 275k on it. It’s in very nice original condition and I am either going to sell it or convert it to the manual trans. If I won the lotto, i would send it to get restored. . I am 60 years old and I have had the truck for...

This rust free FZJ80 has had almost everything touched throughout the vehicle. It was built for extensive overland trips and global travel and it comes with everything needed to do so. This vehicle is ready to drive across country or do the Pan-American Highway right now. Mechanically this...

Searching for the following parts: 82164-60013 (WIRE, FRAME) I think this is the harness that goes from the front locking differential, to the connector near the passenger side frame. 82165-60081 (WIRE, FRAME No. 2 w/ DIFF LOCK & ABS) I think this is the harness that goes from the rear locking...

Anyone interested?

I dont really have a build thread for my truck or anything, but made this thread so im not just spaming the "what did you do with your 60 this weekend" thread. This will just be stuff for my @TRAIL TAILOR coil conversion done in my garage at my house. Photos, questions, etc. Thought it would be...

Hi all! After working over both of the 2H engines that came with my HJ47 Ute it seems both are low on compression and needing rebuilds. Luckily I've obtained a complete HZJ75 troopy as a doner car with a 1HZ turbo and going to attempt s conversion but have a load of questions before removing...

I've searched a fair bit but can't find much info on this. I've got an Iveco daily 4x4 rolling shell. I'm most of the way through putting and LS3 in it but fuel prices have made me change my mind :/ So I'm thinking about buying a wrecked 200 series or 79 series and putting a 1VD into my...

Hi everyone We are Ernst & Jiew from Switzerland/Thailand and traveling trough USA. We love it. We are considering for better comfort a roof conversion. Who does something like this here in the West? What are the price here in USA? Is it maybe cheaper in Mexico? Thanks a lot for your answers...

I’m doing a PS conversion on my 78’ 40 without cutting the stock column. This vintage has a rag joint to connect the column to the manual steering box (see photo). It turns out an early 2000s ish tacoma lower steering shaft have, from what I can tell (confirming in person this afternoon), the...

HI All , Ive got me an 84 chev g20 van into which Ive just installed 92 or so 80 series running gear in it, including axles, 1HDT and hydro A442F. I got then thing running on the weekend and for whatever reason it wont fire at all when cold, a quick shot of ether and it lights straight up and...

Hi, I have a 1965 FJ40 that I daily drive. Winter has come here in northern Wyoming and the stock wiper blades aren't great. Does anyone know of a part number for a wiper arm that accepts modern J Hook wiper blades that fit on to the early FJ40 wiper motors? Thanks!! Sheldon

Figured since I’m doing this I’d make a thread in the event it would be beneficial to anyone. So far we have done the fronts and I ran hard lines. Going to tackle the rest this weekend. It’s been pretty simple so far! We had to get some flexible hoses that were longer than the ones provided...