vbvagearhead

Bought this planning to build it like my old GX, but have since decided we need to have a truck as a third vehicle. I am the fifth owner, started life in New York and came to Georgia. Clean title 193500 miles (may increase) $11,500 Good: No...

2006 LX470 Galactic Gray Mica Gray interior 306k miles I purchased this rig in June 2023 as the 3rd owner. This was purchased as a secondary vehicle that I was going to build into an off-road/travel rig. However, life happens and last year I...

Bump for price adjustment.

Those seats look familiar ;) GLWS buddy if I was in the market for another this looks like a rock solid 80

Pics

Pics

1995 Toyota Land Cruiser 201,xxx Engine refresh has 4000 miles Rebuilt head with new seats and seals Toyota head gasket ARP head studs OSK Timing chain Rod and crank bearings All seals and gaskets are Toyota Replaced front main, rear main, oil...

PM’d you

Sounds good. Let me know. I can probably deliver it as well.

I'm local and interested. would have to make a couple phone calls. and clear a bit of space for it.

Bump $50 and I’m willing to ship it if you pay and set it up.

Looking for a good used W56 5 speed manual transmission for my son’s 1992 Toyota 4x4. I live in Knoxville,TN and could travel around 3 or 4 hours outside the area for pick up.

$250 obo.

Price adjustment to $300

I have a Borla cat back exhaust that came off of a 97 80 series. There is nothing wrong with it. It was pulled to reroute the exhaust over the frame. It sounds good and functions like it should. The previous owner had a new O2 bung welded in. The...

Will take them - PMd.

Camburg upper control arms for a 200 series. They are clean with no rust. The ball joints are smooth, but would recommend replacement as one taper would come loose. Wife wanted it back to stock. $150 plus whatever shipping is.

Few more pics

I am selling a set of axles that I bought a few years ago from Greg Smith , if you seen the top truck challenge ute LX450 with the Domino sign on top thrn you know who I am talking about. These are the oem axle from that LX that he build and...

I think I have it. Going to put eyes on it in the am, one last time and burn it in, then start on body panels. Calling it for the night.

Been working on that. Figured less work. Did not want to get too long in wheelbase with 35's for break over angle. I have been using go jacks and ratchet straps by myself. Had to take a break. I am within 3/16 of square and frame looks...

I drove down to NC yesterday and picked up a BJ44 hard top. For some reason I thought a 43/44 was 10" longer than a 40. Now to decide about cutting this one down, or stealing the top off my other stretched project??? The 43/44 is 14" longer...

Frame is square and welded. I need to add some fish plates but it did not fall apart when I raised it on the lift😁

No turning back!

First cuts are the deepest😊