connector

I bought a used OEM spoiler for my LX470 and would like to find female connector for the high mount brake light to make it fit exactly like factory. I know this is waterpoof connector that is also used by toyota for ABS sensors. Can someone help me find the part number for the female connector...

working in the engine compartment today I came across this. Is it something important? Can anybody identify what it is supposed to connect to?

Thought this would be simple but OMFG. Can anyone explain how the molex connectors on the courtesy door switches pull apart? I see the locking tab but can't figure out how to release the side on the wiring harness to pull the old one out. Two bleeding holes in my index finger summoned this...

I've done this once but don't remember how I did it. I'm pretty sure there is a thread here that explains how or maybe someone answered this quastion the first time I did this. I don't see any pin locking mechanism on the OEM connector. I think it is just a matter of pulling the pins out by...

Hi, I am new here. I am trying to figure out what these wires and connectors are for, and what do I connect them to on a 1983 Toyota FJ40. I am asking about the connector on my hand, not the one for the washer fluid pump. I removed the washer and the radiator tanks to take this picture...

Put the truck on the lift to give her some much needed love and found this loose plug? Any idea what is it for? It’s on the driver side.

Hi Guys and Gals, the title says it all. Here's a couple of pics that will help explain my situation. The PO messed up the plugs. I couldn't find a source for the plugs. I would fab up another connector if I could find the plugs. Any suggestion would be greatly appreciated. I've searched...

I'm looking for the connector to the TPS harness on the engine/body harness side. Need it to be in good shape no cracks with pigtail.

Does anyone have a source for this connector—the side that clips into the TPS sensor harness? Otherwise, I'll just have to source one form another LX/LC.

Hello - my 79 has a DUI distributor conversion . The factory coil and igniter are still installed but all the connections except one are disconnected. The connector comes out of the igniter - goes to the negative coil screw terminal and then plugs into a green connector on a yellow wire in the...

Hello, everyone. I wanted to see if anyone was able to find aftermarket of universal connector that fits the defrost switch. I don't like the look of aftermarket switches and have been using defrost switches for everything from air pump to lights in my LC. Currently connecting each wire...

I bought a 1996 80 series from a buddy (who was a Mud member, owner before him was a member as well) last October, and this forum has been a great resource since then. Decided it’s finally time for a post. I was replacing my battery today, and found this connector laying in the bottom of the...

I have this melt down that occurred from the ignition switch to the connector. Two wires, I can't tell what color they were. The female connector wires were Black with a green stripe and black with a blue stripe. Any ideas why the melt down happened between the switch and the connector?

Been getting p0440 code. I can clear it but will eventually come back in. Few weeks. look at the evap canister on the. 98 lx470 and noticed that there should be a hose connected to the canister looked for a loose hose but didn’t see It. Will need to look under the hood again tomorrow. any...

I am supposed to drag a trailer out to Eastern Washington tomorrow and just realized that I don't have the 7-pin trailer connector. I have a 2016 LX 570 and the part number is 82169-60080. I called Lexus and Toyota and no one has it local. Is anyone willing to unclip theirs and either loan it to...

Car: 2000 RHD LX 470 2UZFE A442F trans The car has been driving fine since I bought it 6 months ago but theres this parasitic draw of 0.4ish amps which goes away with the "alt-s" fuse it has led me to the alternator but switching alternator didn't change anything and the wires in between seem...

looking 4 one of these plugs that goes to dome lights... I know they were used on multiple Toyota’s during this time period. and why no part number? come on! conntinued on next post becuase image limits....

I have done a lot of searching, but can't seem to find a pigtail socket to fit the factory fog light connector. I'm trying to make an adapter or find one already made using a deutsch 2-pin. Thanks in advance.

I need the one that's circled. Previous owner soldered the bulb directly to the power wires. I'd be eternally grateful for a source, a part number, or an offer to sell me your spare. I've looked on Amazon, eBay, and Aliexpress, and can't find anything that seems to fit. Many thanks.