1995 FZJ80
Recently replaced most of the A/C system. Installed new compressor, condenser, dryer, expansion valve, pressure switch. Using vacuum pump, removed moisture and added freon with manifold gauges. Low side pressure was around 25 and high side pressure 275ish (maybe a little higher) with...
Hey all,
My A/C never worked while in Japan, but it was hardly ever an issue with the climate there. When I came back to the states, however, I got the system recharged and it has been working great ever since (year and a half). Unfortunately, the compressor started to go and finally failed...
Hi All,
Just about everything has sold. I only have the SLEE air compressor bracket for a 3rd Gen Tacoma remaining ($85).
Thanks!
I've recently sold my LC100 and have a few extras available for sale.
I'm in Frederick, MD (for local pickup) everything else i can ship for whatever the UPS...
Im looking for just the service ports off the AC compressor, this style. The part held in the hand in the first pic. Second pic shows it mounted to the compressor. I dont need the entire compressor.
Selling some stuff I have laying around to finance my regear and lockers. Located in Southend of Charlotte, NC. Willing to ship on buyers dime.
80 series OME steering stabilizer less than 2k miles: $70 its rattle canned green, and is missing some of the hardware but would be a perfect...
Hello Mudders
This AC compressor came off an early 80's FJ60. I pulled the engine from a trashed vehicle and can't speak to the compressor's function.
It's heavy and bulky, would probably be at least $35 to ship (gut feel). Thanks for your interest!
Regards
Calvin
Hey fellow Cruisers,
I live in Northern Utah, which means in September you use your heater in the morning and A/C in the afternoon. My daily drive is about 15 miles, and my a/c or heater won't kick on until I'm about pulling into my work in the morning or pulling into my driveway at night...
I am selling a brand new, in the box TJM Air Locker and Compressor. All hardware, switches, lines, and instructions included. I bought to put in my 01' Tacoma but am now selling the truck (you can buy the both!) Should fit any non-TRD rear axle for the first gen tacomas and 4runners. Asking...
I face so much creative and helpful content at this forum, so I thought I have to share my modifications on the AHC Reservoir Bracket to convert it to a ARB Compressor Bracket.
Please keep in mind, that I deleted my AHC completely and wanted to use that spot for something usefull. Since I have...
Howdy all,
I was in some pretty deep muddy water the other day. I turned on my rear lockers about halfway through. My rear locker didn't work.
I checked all the wiring and I have power to the little compressor that actuates my locker. I took off the air connector, and a little water spit out...
No AC in the Truck, No Plans to have AC. Compressor is just an Idler pulley as it is. If I disconnected the
lines from the compressor and left them open am I asking for trouble? potentially seizing the compressor
or would it be fine.
:beer:
Is it me? I'm searching all over looking for pictures of where folks set up a dual battery system and having and ARB compressor under the hood.
I have the stock battery now, but have an ARB rear locker being installed this weekend. I want to have the compressor mounted in a position where it's...
I don't know if it works because the AC system had no refrigerant in it when I bought the vehicle and I replaced the entire system before recharging. $20 plus the ride or local pick up in Vacaville, CA.
Just got a 4Runner from TX over the weekend. The PO told me I needed to recharge my '87s A/C system with R12 and it'd be good to go. Bought R12a on Amazon and went to work.
The system held pressure but I could hear some hissing. A/C finally blew cold, but wasn't freezing as I was expecting...
Hey folks,
Bought this to start my OBA project but I'm delaying the project and moving so I'll have to grab another one when I get ready again.
This one looks to be in good used shape! I haven't tested it since I bought it on eBay late last year but had every confidence it would work for my...
Hello,
I’m selling the ARB locking diff and compressor that came with my FJ40. I’ve never installed it on the Truck and I don’t think it has even been installed on mine before. I honestly don’t know much about these parts or lockers at all, but I’m not going to install it and it seems a shame...