78

I just bought these off of Craigslist and decided to go another way. Just trying to recoup the money. The top and sides are for sure manageable with the amount of rust. The doors are bad. They will all probably need bottom skins. I was going to try to make the ambulance doors half doors with a...

Pulled from a 78 fj40 roll bar. Pads are in great condition. $100 plus the ride Located in MO

Can anyone tell me if a 78 Series Troop carrier could work as a doner car for an 84FJ45 build? There is a 78 series accident damaged coming up on auction. Will the axles work or will they be too wide?

looking for the wire that plugs into the rear harness and goes to the side marker. The one with the 2 wire white connector on one end and the green 2 wire connector on the other. Believe they were on the 78 plus FJ40's. Thanks.

I need complete u-bolt set.. thanks

Small rust hole where bolts to body on flat part. was painted by a previous owner some years ago I travel between mobile and as far east as crestview so I can met. Even as far north as huntsville It came off my 78. I went back and forth on if I should have patched or buy new. Im tired...

5.3 LS, 4l60e, Orion gearbox, longfield axles, six shooter knuckles, warn winch, 37" BFG red label crawler tires on race line true bead locks, iron pig rear tire carrier and bumper, 5 point harness seats, west Texas off-road hydro assist steering, 4 link rear and sprung over front. $15,000...

This is how it starts. Just a picture:

I'm posting for a friend looking for rust free ambulance doors. Shipping preferred to Iowa

looking for a fair deal on barn doors (half doors), if there is some rust its ok I can repair them, just need to be straight

For sale, make an offer PM no cracks, good condition.. just need to be cleaned

I am finally getting back on the horse again and going to complete my long-term project. I have a full set of FJ60 axles that I bought completely disassembled that I plan to run under my 78 40. I was able to pick up a full 4x4labs Hi-steer setup for an FJ60 which I know I will have to modify due...

Hey folks, I need a bit of help. I've got a 78 FJ40 with a Chevy V8 that I bought about 3 years ago. It's sat for a bit, since deployments weren't kind to me, but it ran and drove fine when it was last parked. I tried to get it going again last month and had a strange issue with the clutch...

I was wondering if anyone has installed a set of 17" Four Runner Wheels on their 40? My friends had a set that she took off her 2016 and I think that they would look great but wondered about fitment. Would I have to run wheel spacers and machine out the center caps? Thank you for the advice!

I was wondering if anyone has installed a set of 17" Four Runner Wheels on their 40? My friends had a set that she took off her 2016 and I think that they would look great but wondered about fitment. Would I have to run wheel spacers and machine out the center caps? Thank you for the advice!

1978 fj 40. I purchased it thinking I would swap the axles to my 74 40. The 40 came from Globe AZ. The owner told me that Dave from 4 plus did all the work on it. After I got it I decided I would build it up possibly for a everyday driver. So I started going that route and purchased a donor...

Hello. I am new to this forum, so thanks in advance. My 17 year old son scored a rough FJ40 for $500. It runs and stops, and is complete, though rusty. The guy who sold it told us the Holley 2 barrel carb that was on it was dumping gas (his words - not sure what that means) and so we bought a...

Now selling the running engines! 1PZ engine sold 150K KM 1HZ SOLD I'm (WRAPPING UP!) a body swap and a 12 volt conversion on my PZ77 from a LJ78 donor. Also going to part out a HZ 73. Have most of the 73 and 78 series availible for parts. the LJ78 only had 49,000 Kilometers on it. The 73 has...