3fe

Getting ready to ship my 80 from NC and im trying to figure out the shipping weight. It currently has no engine, trans, accessories, AC lines or condenser in it. I know a fully dressed 3fe and accessories is about 700-750 lbs but I have no clue about the a440 trans. I know it's big and heavy...

3fe engine /transmission/ transfercase. Pulled out from a wrecked 62 series. With 115k on odometer. Includes harness and ecu. Asking $2500 for engine,$500 for transmission and transfer case. Willing to assist in getting it shipped Once paid for. Located in Fair Oaks Ranch, Texas 78015 message or...

I am looking for a harness plug from a 91-92 80 Series. The plug I need is the female side from the engine harness that plugs into the dash harness near the ecu. I have attached a picture of what I am looking for with a red circle around the plug needed. I would like to have at least 6 inches of...

I found a project 1991 FJ80 that was local and at a good enough price that I picked it up. The PO had purchased it as a project for him and his son to work on with the intent to use it for light offroading, but it seems that they only made it as far as buying new wheels and tires before the son...

Not sure this is the correct forum, but it’s been good so far. I have a 3FE in my 55, and the engine has developed a howl at the pulley on the front of the crank. While diagnosing, I removed the pulley from the crank and the noise stops. Question is why would the pulley cause a howling sound...

I need a running 3fe to transplant in my 91 LC. I am in the North MS area (Near Memphis)

Working very well from an engine I sold. $250 firm on air flow meter. It has not been tampered with. Intake hoses, send message for all 3 parts or each separate part. Shipping for air flow meter is $16 or less.

Part number 89661-60080 May work on Fuel injected 60 series, but worked fine on 91 80 series. $250 Shipping 50 states $17-$22

Hi im currenty at a stand still with an engine build. My 1970 F155 engine has gone out and its beyond repair. I picked up a really clean 3FE out of a 1992 FJ80. was told it was rebuilt 1500 miles ago. well got it home did leak down and compression. And its horrible 50% blow by past rings in 4...

Pulled the oil pan on my 91 FJ80 with the 3FE to finally tackle the oil leaks! Valve cover and pushrod cover have been done so this was next on the list. Pulled the pan off and noticed the paint on the left side was pretty bubbly. Got to working on the wire wheel and found a few small spots...

I'm looking for the down pipes for 3fe exhaust manifolds. Only need about a foot of each. Must have the flange that bolts to the manifold. Thank you!

Hello all. As a long time fellow 3FE owner, I have spent a TON of time going over this engine to make it run its best. There are not many sensors to make it happy, but refreshing the system still takes a while, especially when you have to hunt down not only the sensors, but also the connectors...

I know people have run the 2F valve cover on a 3FE head when building a 2FE, but what is done about the PCV valve that is located in the 3FE valve cover, since it is absent from the 2F valve cover?

Hey all, I recently got my 1992 80 running. I bought it with a seized engine and transmission. Found a used engine I went through and resealed and had the transmission rebuilt. It’s running and driving but it’s slow. When I say it’s slow I mean it’s way slower than a 3fe should be. I’ve adjusted...

Okay, here is the whole story. I bought a 1992 with a seized engine 243k miles. Engine overheated on a hill and chugged to a stop, all things pointed to overheating and seizure. Prior doing anything it cycles through the gears just fine(going from park to neutral as I pushed it around the shop)...

Making this post to save the headache that this issue caused me. For the past 2 years I have had relatively good luck with my 91 land cruiser with 256xxx on the clock, but there has always been a nagging issue at the mid RPM range only when in gear. The truck would surge with a burst of power...

SOLD 3FE and mated A440. No tcase. 265,000 miles on them. Ran and drove when I purchased the vehicle ~ August 2022. Reason for selling, LS swap. Known issues: Main seals and oil pan leaks, probably valve cover too. A440 transmission struggles to shift between 2-3 gear. I tried messing with...

Parting out a 3FE that overheated but was running good until then. Air Flow Meter (Factory) $335 SOLD Intake Hose (all 3 pieces $150 Fan Shroud $75. fan shroud has had minor very repairs made, is fully intact with all mounting Air Filter complete, and clean $85 Intake Manifold with EFI, wire...

Hi all, Hope i'm posting in the correct place. Just purchased a 1991 FJ80. Brand new to the Land Cruiser world but have been a long time admirer. I really had no idea what a huge following this brand has! It's amazing! Our 80 runs good but has some oil and exhaust leaks from what i can tell...

This is a story of the most over-complicated and annoying inconvenience I've ever had ordering car parts in my life, which at the time of writing this, is still yet to be resolved. The time is long overdue for my FJ62 to get a new radiator so naturally, I went with CSF as they are the only ones...