Hi im currenty at a stand still with an engine build. My 1970 F155 engine has gone out and its beyond repair. I picked up a really clean 3FE out of a 1992 FJ80. was told it was rebuilt 1500 miles ago. well got it home did leak down and compression. And its horrible 50% blow by past rings in 4...
Pulled the oil pan on my 91 FJ80 with the 3FE to finally tackle the oil leaks! Valve cover and pushrod cover have been done so this was next on the list.
Pulled the pan off and noticed the paint on the left side was pretty bubbly. Got to working on the wire wheel and found a few small spots...
Hello all.
As a long time fellow 3FE owner, I have spent a TON of time going over this engine to make it run its best. There are not many sensors to make it happy, but refreshing the system still takes a while, especially when you have to hunt down not only the sensors, but also the connectors...
I know people have run the 2F valve cover on a 3FE head when building a 2FE, but what is done about the PCV valve that is located in the 3FE valve cover, since it is absent from the 2F valve cover?
Hey all,
I recently got my 1992 80 running. I bought it with a seized engine and transmission. Found a used engine I went through and resealed and had the transmission rebuilt. It’s running and driving but it’s slow. When I say it’s slow I mean it’s way slower than a 3fe should be. I’ve adjusted...
Okay, here is the whole story. I bought a 1992 with a seized engine 243k miles. Engine overheated on a hill and chugged to a stop, all things pointed to overheating and seizure. Prior doing anything it cycles through the gears just fine(going from park to neutral as I pushed it around the shop)...
Making this post to save the headache that this issue caused me.
For the past 2 years I have had relatively good luck with my 91 land cruiser with 256xxx on the clock, but there has always been a nagging issue at the mid RPM range only when in gear. The truck would surge with a burst of power...
SOLD
3FE and mated A440. No tcase. 265,000 miles on them. Ran and drove when I purchased the vehicle ~ August 2022. Reason for selling, LS swap.
Known issues:
Main seals and oil pan leaks, probably valve cover too.
A440 transmission struggles to shift between 2-3 gear. I tried messing with...
Parting out a 3FE that overheated but was running good until then.
Air Flow Meter (Factory) $335 SOLD
Intake Hose (all 3 pieces $150
Fan Shroud $75. fan shroud has had minor very repairs made, is fully intact with all mounting
Air Filter complete, and clean $85
Intake Manifold with EFI, wire...
Hi all,
Hope i'm posting in the correct place. Just purchased a 1991 FJ80. Brand new to the Land Cruiser world but have been a long time admirer. I really had no idea what a huge following this brand has! It's amazing! Our 80 runs good but has some oil and exhaust leaks from what i can tell...
This is a story of the most over-complicated and annoying inconvenience I've ever had ordering car parts in my life, which at the time of writing this, is still yet to be resolved.
The time is long overdue for my FJ62 to get a new radiator so naturally, I went with CSF as they are the only ones...
Hey everyone I'm a long time lurker first time poster. I need help. This is gonna be a long post...
92 3FE
So I've been fighting a getting too warm but not necessarily overheating issue. In summer NorCal 100ish degrees truck will get up to about 210°. If I turn on the AC (converted to r134) I...
My son and I are rebuilding a 1991 80 series with the 3-FE and need to find the plastic battery tray OEM or aftermarket .
We also need the "Air Pump Stay" part number 17318-61060 per PART as new or used. I believe this part was used on the 60 series with the 3-FE as well. Any help finding...
Having my 3FE engine and transmission swapped out. Engine runs well, clean, transmission is in good condition. Have some documentation of work done on the engine in past years. Will not include the A/C or transfer case. Buyer will need to pick up. The shop doing the work will load it into your...
Wife & I decided to keep FJ40 and are doing the restomod using the 3FE engine, 5 speed transmission, and 60 series axles with disc brakes! I just got back from a trip from NC to VT to Cruiser Parts to get my stuff; see pics.
I also picked up a small AL gantry crane to roll in and out of my...
Hello all! First of all I want to thank everyone on this forum but being an absolute life saver throughout my restoration. I've decided to take the project in another direction, so here we are.
The rig was a one owner bone stock 1987 60 and driven by an older couple, pretty much the dream 60...
Hello mud -
Posting for sale is my 1991 land cruiser, 3 owners but technically 2 as it was bought from a single family owner that traded it in at wilsonville toyota. Clean carfax and exceptionally clean rig.
The interior especially is top notch.
133,XXX miles going up as a daily driver...
Hey guys!
I’m having a no start issue on my 1992.
I have been daily driving it for about a month with no issues out of line with a 30 year old car.
Yesterday my wife and I took a trip to the Bay Area. It’s about a 100 miles there and 100 miles back. No issues on the road or even over the...
Will ship! Buyer pays.
Specs are: 1 pallet, 5" over hang front/15" over hang in the back. About 750lbs.
Buckeye Arizona 85396 residential
$2000
1992 3FE / A440F For Sale
143,700 miles when pulled (LQ4 Swap)
New plugs,wires,cap,rotor,water pump,AFM,valve adjustment
Has AC,PS,ALT,SMOG,STARTER...