As per advice from many, I am about to take the plunge and get LED bulbs. However, where does one get them, and for the headlights, is it plug and play, or do I need new wiring harnesses?
1HD-T engine with 207,581 km (128,984 miles). It comes from 02/1992 HDJ81
Engine is in good condition. Starts easy and runs smoothly. Videos of engine running will be uploaded later
Comes with brand new OEM timing belt, idler and thermostat
Price is $6999 USD
Freight and delivery charges are...
1HD-T engine with 216,377 km (134,450 miles) on it. It comes from 11/1990 HDJ81
Engine is in extremely good condition, very clean. It has been test run before taking out and it starts easily and runs smoothly. Videos of engine running will be uploaded later.
Has brand new OEM timing belts, idler...
For sale is a 1-HDT diesel injection pump out of HDJ81. It was fully rebuild with a lot of brand new Denso parts in it so it's condition is nearly as brand new.
The pump is $1299.99 USD (core deposit of $700 is required)
Shipping is extra. Core deposit is returned upon receiving your old pump...
Hey there, folks.
I'd like to sell my 1991 HDJ81. Here's a bit about it.
* It was imported from Japan with all the appropriate customs and EPA paperwork.
* It's titled in Oregon and registered until 2020.
* Right hand drive!
* It has the 1HD-T turbo diesel engine and 4 spd automatic...
Upgraded to aftermarket turbo when doing the motor swap on my HJ75.
1HD-FT Used OEM Turbo, This turbo was in good condition, but not sure on exact mileage. $350
I am thinking about upgrading to a Mean Green alternator and starter. Anyone on here have the part numbers for the starter and alternator for a 1HD-T engine with a five speed manual and air con?
I noticed recently that my Land Cruiser with 1HDT was pushing a bit of coolant into the Overflow. I remove the head and did an inspection. I found cylinders 4 5 and 6 we're leaking on the right hand side of the Block near the back into the water jacket. I checked the cylinder head for...
[Cross posting from 80 series tech forum on inkpot's suggestion]
Hi all,
My 4.2L 1HD-T 80 series is experiencing some serious oil usage. I've narrowed it down to the rocker cover breather outlet; temporary catch can collected 250-300mL of oil on a ~50km test run.
There is some variability...
Hi all,
My 4.2L 1HD-T 80 series is experiencing some serious oil usage. I've narrowed it down to the rocker cover breather outlet; temporary catch can collected 250-300mL of oil on a ~50km test run.
There is some variability in the amount of oil collected. Driving at ~80km/h (about 5 PSI...
So I have an 80 series and have swapped in a 1hd-t, I have now moved to PEI Canada where it is damn cold in the winter and am considering swapping in a Webasto heater. I have seen a couple of install threads but they are all installed in RHD cruisers which means I don't have the same amount of...
I'm a new owner of a 1991 HDJ81 and am looking to sort through the truck before putting it on the road.
I went to order some ACL Duraglide big end bearings after hearing about this as a preventative maintenance item (truck has 135,000km and probably has never had them replaced).
I ordered some...
I wasn't able to find any posts dealing with the 1HD-T (HDJ81) regarding what the proper coolant level should be and when to check it. I also looked at the FSM for the 1HD-T (page CO-3 and CO-4) and couldn't find any more elaboration on this...
So, when I check the coolant in the plastic...
Tried searching but I keep getting flywheel diameter.... I'm looking for the overall length and height of the 1hd-t motor from the front of the pulleys to the back of the block and the height from bottom of oil pan to top of the intake pipe.
I have a 92 4.2L 1HDJ-80L Diesel motor in my unit.
it currently has 284,000K on it and looking to see when it might to start have problems.
No leaks anywhere to be seen, stays the same oil level between changes or cant tell to the naked eye.
Mainly road miles, and a little light off roading...
Just under 237,000km (147,000mi) on this recent JDM import. I wanted to do the BEBs and see how things look in there. I was pleased. And the job went well.
I bought an 89, 1HD-T and A442F trans w/ Xfercase from a guy on IH8MUD about a year ago. My business is growing, and I no longer have time to do the project.
For Sale - Fully refreshed 1HDT, A442F + LC80 conversion parts
You can read the description there with videos and pictures.
I also...