What Did You Do With Your 120 Today? (5 Viewers)
- Thread starter kbahus
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Painted my MetalTech Sliders. Cleaned and scuffed with Dawn & hot water and a Scotch Brite. Primed with two coats of Rust-Oleum Clean Metal Primer. Sprayed three coats of Rust-Oleum Bed Liner.
Last edited:
Changed the gas cap, got new shoes and dipped the rims.
Ordered parts yesterday for leaky radiator (ordered a denso), and parts for a valve stem seal job which I'll be tackling in about three weeks.
Ordered parts yesterday for leaky radiator (ordered a denso), and parts for a valve stem seal job which I'll be tackling in about three weeks.
Damn, talk about rubbing it in!
Hey! I only included working and pre-fun pictures.....I thought rubbing it in would be if I included the pics of how fun the waves were or of the Hawaiian Tropic girls that showed for a photo shoot while we were there!
As with anything else on these pages.... pics or it didn't happen
Last edited:
I installed 24,000 lumens worth of high and low beam LED bulbs, and ordered my secondary shock setup for the front, valved and remote resi 2.5 icon shocks for the rear, and jounce bumps all around.
- Thread starter
- #352
Started the winterization process today by pulling the rubber plugs and blowing out my rockers of dirt and grime. From there I sprayed the inside of the doors with Fluid Film. Hopefully I can knock out the full Fluid Film treatment in the next week when time and weather permits. I also procured some front brakes off a 2016 4Runner for a big brake upgrade while taking care of a seized caliper at the same time. Last but not least, I broke my 3rd brake light trying to get that sucker off. I noticed some water trailing down the glass from above during the last rainstorm and figured the light had to be the source, looks like it was too from the dried water spots I could . Now it's really going to leak!
Last edited:
Hey gang. I'm new to the GX world. I've had several Land Cruisers, and love this thing! It will remain fairly stock other than a 2" lift, as my 80 is unstoppable on trails. I got the GX specifically as a dune basher, and it kept an ear to ear smile on my friends and my face all day at the St Anthony Sand Dunes in ID. There's just something about rallying around a 35 degree bowl doing 50!! I love this VVTI. Got a lot of wtf looks as I rolled up in my luxury SUV!
Last edited:
- Thread starter
- #354
How did you attach that flag?
Timing belt and water pump. Just a side note, KDSS makes it a little more difficult to reach a couple of the bolts that are needed to do the job. This is my 5th UZ family timing belt that I've done. Not bad in a GX.
I channeled my inner MacGyver, got an L-bracket, some left-over 1/2" copper pipe, and of course the most important MacGyver tool, duct tape. Bolted it in where the factory hitch bolts.
NMBruce
SILVER Star
need to do something this winter to mine, looks good
I ordered the power stop z23 kit Sunday night. I should have time to install tomorrow or Thursday. Hopefully, these work out well.
Upper hoops shipped as did the secondaries! Just waiting on rears, jounce, and custom adaptors for the tie rods
