Meet "Fat Amy" my Amazon Green 200 Series
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Wanted to do that one but was solo with no sliders on my rig. Are sliders really needed?
- Thread starter
- #923
Probably not absolutely necessary if you have a lift. But you'd have to go slow. My truck is very tall so I was not making contact where others were.
- Thread starter
- #926
Even the ones I don't delete are stillshitty.
Did yall have a producer? Those should be in a commercial.
- Thread starter
- #928
I know, right?
No producer, just beautiful scenery and a photographer that knows what he's doing.
No producer, just beautiful scenery and a photographer that knows what he's doing.
Wish I had planned better. I was in GTNP instead.
- Thread starter
- #933
Without measuring, I can tell you the lowest point is at the bottom of the rear strut mounts.
I'll have to take measurements there and below the 3rd member.
I think he's asking about the lowest point in the break over zone between front and rear wheels.
- Thread starter
- #935
That I'll definitely have to measure; thanks go clarification @BMThiker
- Thread starter
- #936
@Tapage , 3rd member is 9.75"
Beak over point (if counting rear lower arm mounts) is 15"
Break over (from bottom of transfer case) is 16"
Beak over point (if counting rear lower arm mounts) is 15"
Break over (from bottom of transfer case) is 16"
- Thread starter
- #937
Pic by @Willy beamin
- Thread starter
- #938
found Steen's Black Bear Pass video too...
Had a great time staring at Amy's ass all day!