CX racing header and downpipe

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Got it. Well, I hope it holds up. I'm going to powder coat it inside and out with high temperature silicone powder coating. It's good to 1200 degrees and I've had decent success with it. It's not as tough as ceramic coating but should hopefully extend the life of the header
 
I used to do the ceramic coating also but don't offer it anymore because it's a PITA but I may coat these for old times sake. It does have nice durability. They will get something for sure. Cheap stainless sucks, like the ems stuff
 
ma
The CX header is the only current production one I know of. Anyone know/recommend any others?

magnaflow.

97sept14b.webp
 
MagnaFlow doesn't make a header though, it would be nice
 
Got it. Well, I hope it holds up. I'm going to powder coat it inside and out with high temperature silicone powder coating. It's good to 1200 degrees and I've had decent success with it. It's not as tough as ceramic coating but should hopefully extend the life of the header

I read my EGTs about 2" down the #1 exhaust manifold runner. I often reads over 1400, so I would go for the coating with the highest temp rating. John
 
Anyone have problems with broken/stripped bolts while removing stick manifold?

I'm not replacing the stock manifold, just one of the gaskets... You think the flex joints will allow me to replace just the back gasket without disturbing the front portion of the manifold?
 
Anyone have problems with broken/stripped bolts while removing stick manifold?


common problem. i broke two on each one of my 80s. a torch, a vise grip and plenty of patiences saved the day.

97sept14d.webp
 
So here is my update on the cx racing header. I got the ports cleaned up and hi temp coated. I did a test fit and had some issues. First, the mounting holes are large so you have to kind of hold them to center the manifolds an d hope your ports line up. Second, I discovered they don't work with a TRD supercharger. The front manifold pipes (2 of 3) come up out of the port and cause interference. I had to cut it apart and remake the two pipes. I got it done and it barely fits, but I think I'm good. So, be warned this is quite the project but I still want to try a header so I push on. The truck is still not done yet so I'll post up more as I slowly progress. Here are pics of the mods
 
Before
20150604_123832.webp
 
Cutting apart
20150604_142352.webp
20150604_143354.webp
 
20150604_145649.webp
Cut off saw and eyeball to rearrange the pieces to fit
 
20150604_160211.webp
20150605_063830.webp
20150605_063849.webp
 
All tig welded back together
20150605_092625.webp
 
Coated and ready
20150605_114730.webp
 
Back
Top Bottom