The guy who sells LC wiring... Cruiser Wiring
Has anyone dealt with this guy recently? I placed an order with him and was told by him it was shipped out two and a half weeks ago. I have not seen the package and I have not gotten any response to my emails for the last week and a half. No...
I installed a brake controller and a 7 pin (hopkins) female for the purpose of towing an airstream. It's all hooked up, but not communicating with the trailer, confirmed with test light/om meter.
My 08 has the hitch, and female wiring adapters for the 7 pin harness, but is it possible it's not...
Recently, I purchased a 2008 LandCruiser for the purpose of towing our family airstream. It did not come with a wiring harness, so I purchased the hopkins plug in harness for the factory tow package. It has a 7 way and a 4 flat as well.
Install was simple enough, few bolts and two plugs that go...
So i'm swapping in a 2.4LTE into my 84 long bed that had the 2L in it. on the engine stand i got power to the ecu hooked up the batteries and jumped power to the spill valve. the motor finally started but was revving high and blowing tons of smoke like the pump was way over fueling. any ideas on...
I just got a pair of Labrak's ARB fog replacements and ordered a pair of the rigid dually flush mount lights to put in there. My fog light switch currently turns on the ARB fogs and have done the mod to allow them to stay on with high beams.
Can I use the factory wiring harness to power the...
Searched but no luck.
I just installed a Slee rear bumper and now have nowhere to install the factory trailer wiring plug. So I guess my questions are:
- has anyone found a mount to relocate the factory plug into an aftermarket mount to then attach it to the Slee?
- does anyone have the color...
this is the complete front and rear wiring harness.
Lots of the end connectors need to be replaced. It's in good condition overall. After having to replace sections of mine recently I understand the need for a complete harness so I took the time to remove it.
$120 plus ship
I replaced my alternator and voltage regulator and it still won't charge my battery. It will die if I unhook the positive lead from the battery. I'm not sure what is going on. Do any of you have a wiring diagram for the alternator and voltage regulator for a 1969 40 series.
Finishing up a new subwoofer, and I need to supply power via the "accessory" mode. It's the connection that shuts the sub off when the truck's off since its main power is direct to the battery.
Hey guys, looking for any insight on wiring an ez wire harness to my existing steering column. I have listed what I have below currently. I'm not much of a wiring guru but have made it to this point and I'm eager to get the rig fired up and not ON FIRE.
EZ wire
-ignition switch start...
i have 5 led lights 4x 5inch floods to go on each corner of my roofracks and one 12 inchto go on the rear of the roof racks. I want each corner light to turn on from one switch and the 12 inch and the two back 5 inch light to turn on when I put it in reverse. now some lad helped me out but I...
My FJ60 previously had a V8 swap and I'm finishing up my diesel swap. There are a half dozen connectors by the drivers side fender in the engine bay that have long since been forgotten.
Most of them have switched power going to them still, so I would like to use them. I would like to know...
I have a 5.0 V8 EFI from a 1993 Thunderbird with complete running wiring harness and computer. It also comes with a NP435. Includes alternator, fan, complete air intake. Everything you need to plug and play into your truck.
Mileage is unknown on the engine and transmission. It starts up and...
Hi,
I'm in the process of a full shell swap, everything is fitted, but trying to find out where this eyelet near the bell housing goes. Sorry, I didn't pull it out, so I don't know where it went.
Thanks!
I found a issue with my 100 last night. There is a hole worn in the drivers side wiring harness back where the previous owner had installed an inverter.(in the Subwoofer Space)
I am really surprised I haven't seen any issues up to now. Only discovered it because I was adding some stuff and...
My '66 FJ40 has a really old wiper switch and the really old top mounted wipers. What do all the wires on the switch do? I assume it has something to do with parking the blade. Do they all need +12? Or is it more complicated than that.
I found a REALLY nice set of 2010 Acura RDX seats in a U Pull. Black leather, heated, great condition. Car even had all the glass intact and heater switches there. Bad parts are the rails are a little wide, they are expensive, $97 each and i dont know if the airbags need disabled.
Thats my...