Hi All, I have standard 100 series 4.7 2uz-fe. The soft engine/splash protection under plate/tray has a 'window' for oil changes attached by 2 bolts. Mine is gone. Any know the part number to replace that little 10inch access plate? I'm not looking for the front unit that allows access to oil...
Hi everyone,
Left rear window was fine for a while, but was pushed down and now can't go back up. It has a lot of slop, where I can pick up the window and pull it up, but it droops down. Motor doesn't do much of anything.
There seem to be a few things that commonly go out on these. I've read...
Set of factory 60 series sliding windows
Rust free
Factory glasses
Factory latches
Factory dividers
$775 USD.
I have videos of them showing the condition. Feel free to get in touch if you’re interested.
One of the best mods for your 60/62s. Your dogs would love them too!
My passenger front window has an issue I can't figure out. It works one time then stops quarter of the way and works again if unplugged and plugged back in. Attached is a youtube link to a short video I took of the issue. I've replaced the motor, switch and drivers master switch. All other...
This little nub broke off clean from the bottom of the channel that holds the glass. I’ve tried welding it but the weld doesn’t stick. My knowledge of welding is limited, but it feels like this isn’t regular steel and so it’s not melting together. I’ve tried coming up with a bolt together...
Finally found my wind noise - right where it sounded like it was coming from too. Top corner of my drivers window. Is this the window channel? Is there somewhere inside I can squirt some silicone? What’s my next step? Wow it sounds so quiet now - I can hear what I’ve been missing ;)...
My passenger window switch is broken, after taking it apart, it looked like damage the actual board itself. I still have the bezel and functioning lock switch so I'm in search of the window switch only. I couldn't find any aftermarket on amazon and prices for OEM are outrageous, $50-$100 just...
Picked this bronze tint up from a member a while ago but no longer have a use for it. Enough tint for two front side windows(driver and passenger). Was purchased from a mud group buy. Located in Southern California. $200 + shipping
Jesus Christ. Please help.
My drivers window stopped working, so I replaced the motor and regulator this evening. After that was done still, I could not get any movement even out of the new system. My window was stuck down in the winter time here, and I was in a bit of a panic, because I am...
As the title states, my driver-side window is not working, and I plan to order a new motor and regulator. Looking online, prices range from $45 to about $120.....I'm new to this, so can someone point me in the right direction regarding brands or where to order from? If there is a specific part...
Electric to Manual Window conversion kit -
Eliminate the anxiety of never knowing if your window is going to go up or not..........
(4) Manual window operators & bolt hardware Correct operator for each specific window
(4) Door Cards - front passenger and rear passengers removed from a blue/grey...
Looking for a used or new (perferably used to save some money) brown window crank knob/handle for an 83 FJ60. Also interested in the plastic ring that sits behind it, thanks!
I like the way tint looks on some LCs but tintless windows look great on older LCs. What do you guys think? Pros and Cons? I acquired mine with dark tint, not sure if I should change it or remove it.
So I have searched around I'm not sure if these are still available from Toyota or if there are aftermarket options but I'm really having a hard time trying to find gaskets for my windows. Here is a picture of what I mean. Any help would be greatly appreciated. Thank you in advance!
There is a strip molding (I don't know the correct word) that snaps into the body under the rear side window. I need to install this, but I can't figure out a way to get under or aside the window in order get this in.
If I install the clips into the molding, there is not enough room to get...
Do y’all know if the window frames for the 79-83 models are the same dims as the 84-89? Reason being is I want to swap some vent windows in my ‘82 and there’s a lot more doors laying around for the later models. Thanks!
So the 100, finally has some window concerns and i could use a line on who can help. The driver rattles, the passenger likely will soon and the back two have spoken up.
One will go halfway down then drop, which i've gotten back up by pulling panel. The other is behaving similar, but hasn't...
Just started happening in the last couple of days, but whenever I roll up my rear window, it would immediately roll back down. Even if the button remains pushed. It doesn't stay up. It's raining outside and I have no way of rolling it up. Does anyone have this issue before or know what I need...