starter

Is starter relay 28300-54070 interchangeable with 28300-17030 ? I have 2h 1988

I am pulling the 12V starter and starter relay tomorrow. If bench test shows that either of them has failed what options are there for repair or replacement. This is an early (1975) B engine. Just looking for options other than a swap to a different engine configuration. I sure miss driving...

Hello, I'm looking to have my mechanic replace the starter preventively on our 2016 LC (120k miles). Do most people go with the OEM or is there a different one? I didn't see a clear consensus in my search on the site. I'm also having them replace a door lock actuator. Was going to buy that...

The starter was in working order but rough cosmetically and around the edges when I removed it. Had it rebuilt by local master at his trade. Told him to go through and replace/rebuild anything that showed any sort of wear or would wear out in the years to come. Brand New: OEM field casing/yoke...

So, there are times when I crank my 100 and.... I release the ignition too soon, it happens. I then re-crank and it turns over and she sounds like a jalopy. It kind of does that like clunk engine sound and then cranks over. Honestly I don't think much of it, but today, today was different. I...

For my 2001 LX470. I'm about to buy a set of these: https://spartanpower.com/product/jumper-cables/ But what AWG is required? I think the 20 ft ones would be more useful, and then I'm looking at a voltage drop calculator: https://www.calculator.net/voltage-drop-calculator.html But I don't...

My starter failed. Prior to failing, my engine would typically fire to life after engaging the starter for maybe half a second, to perhaps a full second. I replaced the starter, and as part of the process replaced various gaskets, knock sensors, and coolant sensor (not sure if at all related)...

Original Denso starter off my 97LX. $80 shipped USPS CONUS

i am updating / upgrading as much OEM icing on the 28100- cake to my 1FZ-FE Starter Motor Kit's as i can in lock-step to my other various ones - RED OEM Yazaki main B+ Lug Boot - but the actual mounting hardware is a tad confusing , as i do not have access to a FZJ80 / 1FZ-FE ? - i see...

Getting a wicked grind or grind sounding rattle after I release the key when starting our 2001. First thought was starter when my wife told me about it, but it doesn’t happen until the key is released - not when turned to start and not when vehicle fires up but before releasing the key. Where...

I saw a very good thread a long time ago (when I purchased my GR starter) that explained very simply how to wire it, replacing my stock 77 starter. Now when I search I find tons of posts regarding the starter but they all seem to assume that I know how. If I get this correct, I use the wire from...

Long story short my wifes 60 sat in our garage waiting for its heart transplant with the engine/trans/transfer out of it. Our puppy labrador decided the starter wires looked tasty to chew on. Pics are what is left. LS in in now and I need to wire the starter, and need to know what each wire is for?

I still have the original starter on my 1981 US spec FJ40 and after trying to turn the truck over the past few months, it does start to bog down and struggle and feels like it’s on its way out. Therefore I’m looking for a “newer tech” gear reduction starter. I just need more “ooomph”! Can...

Hi all what are the best options for a new starter for a 22r?

So when I go to start Lexi, especially when it's cold, I might get a short grinding noise, and the starter will just spin. I let off the starter of course and usually the second (or third time yesterday) it will engage and start. Is it serviceable?

Back in September, the night before I was to leave for the rubicon, my tundra died. Nothing, nada in terms of cranking. 16x,xxx on the clock. I borrowed a truck from a buddy and left the next day. The wife took care of getting the truck towed to a shop and they replaced the starter. I assumed...

I probably know the answer to this after exhaustive searching, but I wanted to throw it out there to see if there is even the slightest hope. For background I am about as mechanically inclined as a bowel movement, so that could be the ultimate limiting factor, but I do know some fairly bright...

its really looking like ill need to take the steering shaft out because going down means front cv shaft out out.

Hi folks -- I have a 2011 LX with 150k miles on the clock. Starter is original. Never had any issues until tonight. Here's what happened... Tried to start and nothing happened (maybe some clicking?) Pressed start again and didn't start Pressed start again and heard clicking Turned vehicle...

Wanted to jump in and say hello now that I'm part of the 100-club errr, umm... the LX470 club. Just picked up this beauty, a 1999 LX470 from Southern California. Has around 283k, but with records of an engine swap/rebuild about 20k miles ago (donor engine allegedly had 120k miles on it). OME...