hard

  1. PRFJ

    Wanted  Looking for a good shape hard top in Central FL

    Looking for a hard top in Central FL, let me know what you have
  2. 05TDUSSEAU

    Hard Top fitment

    Will a 72 hard top work on a 74? I have a line on one for my 74. Thank You
  3. C

    '73 FJ40 Wing Vent - New Gaskets and Hard to Open

    We put in some new gaskets on our hard doors. We believe that we put the wing vent hardware back together correctly, but the wing vent will only open about 2.5" It has been 8 months since we tore the doors apart, and I don't know if we have done somthing incorrectly. It seems like the wing...
  4. El Gringo Loco

    Hard top removal

    Anyone have a pulley removal set up I can see/rob your design? Tips on removal greatly appreciated too. Newly reconstructed full cap/side panel.
  5. CaptBeardilocks

    Occasional Thump at Full Lock

    Hey All, I have a bit of an odd one here. Sometimes when I'm pulling into a parking space (so full lock left or right turn at slow speed) I get a small bump in the front end that I can feel. Describing it can be hard. The first time was after a long highway run and I thought I just hit a...
  6. J

    Wanted  FJ60 AC Condenser Hard Line

    Looking for an AC hard line for a FJ60 as shown circled in red in attached picture.
  7. cims1970fj40

    Wanted  Hardline fuel brackets

    Looking for the two different fuel hardline brackets for an FJ40 circled in the photo. Located in Woodstock,Ga
  8. G

    Hard brake lines, the same or different?

    Hey all, Does anyone happen to know if the hard brake lines on a 70 series are the same as other models, or are they different? I’ve got a snapped hard brake line on the front, left hand wheel (axle/backing plate to caliper) on a 91 hzj73. Wondering if I can get lucky and pick up a matching...
  9. MPS

    Blown hard brake line. Any sources?

    Hi All - I have a 1996 LX450 and a section of the hard brake line that runs from the front to the back blew out. It is the area under the car that lines up with the front section of the rear leaf springs (hopefully that makes sense). I am in the Lake Tahoe area and my mechanic says they have...
  10. J

    RPMs rev up shifting hard

    Hey good morning, looking for some help have a 98' with 252k miles. It's been a rolling project but now experiencing hard shifting with high rpms, shifting will either cause 0325 or 0330 knock-sensor codes. Feels like it's in limp mode but not getting any codes after clearing 0325 or 0330. Any...
  11. tputterman

    Hard to start when warmed up...

    First thing in the morning my 3.4 starts right up. Once I get to running temp and turn it off it takes 3-4 cranks to get it started. Within the last 10,000 miles I have replaced all spark plugs, injectors, coils, fuel filter, timing belt, and water pump. Could it be vapor lock? Stuck injector so...
  12. CharlieS

    PHH hard line and hose replacement question

    I was going to do preventative maintenance on my PHH, so I ordered the silicone hose kit with clamps from PHHKIt (Pesky Heater Hose Kits - http://www.phhkit.com/). Later, when I pulled my PHH hard line the original paint was completely gone, and there was severe pitting where the PHH...
  13. Zpas1887

    A422f Hard Shifting From 1-2

    Hey Guys I have a 92 vx sahara with a hydraulic a422f. After a 4by the other week I was driving back and noticed it took a little bit longer to shift and super hard abrupt shift from 1-2. It only has hard shift from 1-2 gear all other gears are fine and it will only done it if full throttle...
  14. SchnooderValve

    For Sale  FJ40 Hard Top 1974 for sale $1,100

    Selling the hard top that came with my 1974 Land Cruiser FJ40. Message me for more detailed photos The sides shown in the photos and included with the hardtop do not have the rounded rear glass. However I do have a pair of rounded rear windows available in another extra hardtop that I own, if...
  15. Matt1260

    For Sale  FJ40 hardtop parts and doors

    Hardtop parts off of 1981 BJ40. In PDX. Oregon. All look restorable and are straight with no dents or cracks. All glass is in great shape. Mostly surface rust! Fiberglass top $300 Right panel $100 Left panel $100 Left ambulance door $100 Right ambulance door $100 These are worth a lot...
  16. Cravati

    Anybody stretch a hard top?

    I have a 1977 FJ40 that I stretched to FJ43 specs. I just found a hard top for a good price and I would love to pick it up and stretch it to match. I haven't done that much fiberglass work before, but I'm tempted to take it on. Has anyone on here been able to stretch a hard top and lived to tell...
  17. DocuDude

    Ok, LC 100's are tough to find. How hard is it, to make a 470 have Toyota LC badges?

    I'm a Toyota man Not a Lexus But there are many more 470's to choose from Has anyone else changed the badges in the rear and the front grille so that to the casual observer, they would think I am a Toyota Landcruiser and not a foo-foo Lexus
  18. veiloctane

    Hard time removing injector washer seal.

    I did my injectors today and had a issue with removing 1 injector seal. I was able to get it out with a lot of effort but I may have caused some damage. I tried to split the washer with a flat head screwdriver to pull it out. I went slowly to try and not damage the surface I stopped before...
  19. fj62max

    Throttle cable/kickdown how hard is it to replace?

    I have a hdj81 1991. Beside the mess how hard is it? Do i have to take off the vavle body?
  20. flash02

    FJ40 hard top

    I have, left over from when I had a 40, a left and right side as well two roofs for an FJ40 hard top. No doors or flip up back window. The sides are virtually rust free. The rain gutters have been removed from both roofs as they were rotted out. Glass while removed is in good condition. Any...
Back
Top Bottom