fuel tank

2004 LX. Leaking fuel from the seam, new (used) tank is on the way. I looked through the Factory Service Manual, the SFI section has some info but not a procedure to drop it. Mostly just curious on how to unplug the hoses/tubes/wires. Do I need to go in from above to disconnect the fuel pump...

I am looking for a fuel tank for 80 series 97 (LX450 / FZJ80) Located in Smyrna, Georgia thanks

I've got an NIB fj60 fuel tank. Bought it 2019 or 2020, never opened it, was convinced I had tank problems, but it was just a rusty sender when I figured it out all. I had heard that fuel tanks were going away, so I got one from a local dealer. At the time I had to call around to find one that...

Looking for a clean fj60 fuel tank. Mine had the recall done back in the 90's so looking for a clean tank that wont break the bank to get back up and running. Located in sw colorado Text: 720-975-3767

I checked the little portal under the carpet and found that the fuel tank pressure sensor wire had been chewed. However, I cannot find the other end of the wire. Can anyone clue me on where to look? The sensor points towards the front passenger seat so I figure it's in that direction, but I...

I'm throwing my rig a bit of a 200k mile birthday party, and as part of that I dropped the tank and installed a new fuel pump as PM. The logic for this was the few reports of bad fuel pumps (Teckis, others), or fuel pump ECUs (CharlieS, seems like a couple more) which I believed at the time had...

My wife panicked when she got in my 80 last week and the fuel light was on. So, she did what any responsible, panicked person would do, she drove as fast as she could to the nearest pump and filled the tank with the cheapest gas she could find. Now, to be clear, I had warned her the fuel was...

done

Seeing if anyone has one of these sitting around they want to part with. truck is a 2/76 PM me if you have one! thanks!

I have a good condition fuel tank from a 97 80-series. Had two tanks and had both inspected, cleaned, and recoated and am keeping one, but don't need the other. Will start by asking $600 shipped but open to offers. I don't have anything but the tank.

I have quite a collection of parts that are not going back in my project. I had grand ideas of restoring them all before I sold them (yeah right...) but I really need to clear the space. I can't ship any of these, so this is really for SoCal folks (I'm in Ventura County) who can stop by and take...

This high capacity fuel tank came off my 1982 FJ60. It needs to be pressure tested and possibly welded up on one of the edges. Or, if you can weld, you can make another one based on this one. The dimensions are about 14" H x 34" W x 26"D. There is a 45 degree angle at the bottom rear of the...

‘94 80 1. Fuel Tank 2. Front left interior handle bezel (gray) (same as back left 3. Exhaust heat shields starting at cat. I pulled some off a 96 in 96 degree heat and 96% humidity and they don’t fit. Awesome. It looks like my cat on frame one is supposed to have two bolts while the 95+ is a...

Looking for a place in ABQ or close to that is willing to replicate and build me a new fuel tank or to patch this rusted tank (no reproduction units available.

Cross posting a 1983 BJ42 OEM Diesel Tank https://forum.ih8mud.com/threads/socal-79-to-84-oem-fuel-tank-for-40-series-with-skid-plate.1276193/

I know this is a longshot, but a fair few South Africans on here. Looking for South African supplier of a long range diesel fuel tank for 60 series. I have a 1987 FJ62 with a 4.2d swapped engine. I have always planned to get a long range tank for it. Does anyone know a supplier who does...

the needle in the haystack-fj62 fuel tank Round 1 - Had one snagged out from under me- Round 2 - Found another in NH only to be told it wasn’t available anymore. Round 3 - NH company provided with two options in lieu of their “mix-up” 1) there may be another on the property but it would take...

Looking for 91-97 Fuel Tank Thanks

I have a TLCA-1 Aux fuel tank that was made by sunset metal fab and was/is sold by Vehicle Safety Supply. I have not had much luck from either company answering any questions. Is there anyone out there that has installation instructions, a parts list, and pictures of the tank installed...

I developed the "factory pinch crack" from over filling my OEM tank on a hot summer day and parking on a hill and so, not trusting my brazing skills (though I did try tank epoxy - did not work), I replaced it. The tank is rust free (Nor Cal) and has all the pads. $100 OBO Pick up or can...