Well, just bought this one. Worked when installed and now doesn’t 2 weeks later. ISO another to determine if it’s the switch or wiring. Validated that power goes to the switch, but doesn’t come back out to power the turn signals. Anyone have one of these laying around? Planning to take this one...
These are the last bits of parts i have from my fj40 that i wont be using. I can only assume everything is from a 65ish and 1F engine. i can take more pictures for those interested and i will ship parts.
The wiring harness has a few splices and cuts but can only assume its all or mostly there...
Not mine, but here you go... There's some history on it if that helps.
I nearly bought it for $7K from another gentleman in IA and the frame along with it that needed swapped. I should have done it, but I didn't. That's a mistake on my part. He swaps the frame and tries to sell it with...
Restored front seats out of my 80 FJ40. Sand blasted and POR-15, new foam where needed (surprisingly not much), new Cruiser Corps upholstery. Free local pickup near Tampa, FL. Shipping will be expensive, No way to calculate until destination is known. Thanks for looking.
Over the last couple of days I started the roof rehab. I’m actually pretty happy. The rain gutter trim isn’t totally rusted out and needs little repair work. The shell itself, that’s another story…
Any advice on working on the shell? I’ve considered buying one of the bathtub refinishing kits...
Finally installed the cable and pedal to match the Weber carb.
Original carb and cleaner set up were long gone when i picked her up in 2009. Had a small Carter on there.
Throttle had to push/pull rods and linkages and so was a lot of slop in gas pedal. Enough to make it very difficult to...
For sale Powertrax rear locker for 68-98 Land Cruiser 9.5 inch semi floating axle.
Part number 9220883005.
This was installed in the rear of my FJ 60 for just a few months before I came across a set of thirds with lower gears and an ARB.
It is in like new condition with no rust or damage.
These...
I began the process of rebuilding my heater box, and it wasn't until I began putting it back together that I realized I was missing a part. Im missing the L-shaped Linkage that goes on the driver's side bottom front. Ive been advised that there may be different styles of this part. Seeing as...
Since moving my fuel tank under my 40, I’m left with a space under my passenger seat. To keep it period correct, I want to install a drivers side tool box on the passenger side.
I’m looking for the tool box, lid, seat mount, and latches.
1976 toyota fj40 for sale by owner - Uniontown, WA - craigslist - https://lewiston.craigslist.org/cto/d/uniontown-toyota-fj/7679920085.html
This is a project that I acquired. Its on one ton axles Dana 60 front with a full Detroit locker and in the rear a spooled 14 bolt. The motor has been...
Looking at different headlights for our build. I keep reading about these lights - Toyota (81110-60P70).
I know nothing about these lights. Will these be plug-and-play with the wiring in our FJ or ???
=========== NOTE - These are not mine, contact the seller via the Craigslist Ad =================
https://phoenix.craigslist.org/evl/cto/d/white-mountain-lake-1971-toyota-fj40/7679814257.html
$43k invested. Frame off restomod just completed with a rebuilt 350 V8 with Sniper fuel injection...
https://seattle.craigslist.org/see/cto/d/north-lakewood-1976-fj40-land-cruiser/7679709069.html
Daily driver
4.6 Chevy v6
Nv4500 5 speed
Oversprung
New BFg km3 35x12.5 with full spare
New winch
Swing out spare tire rack
New led lights
New rail lights
New alternator
New battery
Blue tooth/ cd...
1978 FJ40 for sale
We've owned this FJ since 1996 had plans to something with it but time just flies by
All stock except wheels and tires
Original 2F engine 4 speed trans paint is a bit rough but original back sill below the doors has some rust other wise just surface rust on frame ect. Pretty...