air

How do you clean/replace this filter? It seems to be riveted on?

2005 LC 180,000 Miles Preface. I've searched this problem on Mud many times. To no avail. I'm hoping I have a unique fix that I'm not considering. Firstly, I've recently had a mechanic replace my Timing Belt, Water Pump, Fan Clutch, A/C compressor, A/C Pressure sensor and Under Hood relay...

Hey guys I am very noob about how these things work , so I have a 2007 LX470 and I have ARB air lockers installed on front and rear and this rig is still under construction, I also purchased a part time 4WD kit that consists of Aisin hubs and Mark's 4WD part time spool. I am trying to figure...

Good Morning, I am swapping out some springs and returning to stock with airbags. My upper bump stops do no look like many of the stops I see referenced in the instructions or in many of the internet sources. Mine do not "rest" on the top of the spring. They are bolt mounted in what would...

I have a weird situation on my 1987 4Runner air cleaner that I am trying to understand and fix. There's a small bracket that attaches with two screws to the MAF housing. And then, as I see in photos of other trucks, there should a bolt that goes through that bracket and into the air filter...

Pulled from a ‘88 FJ62. Immaculate condition, no rust in or out. I have no use any more with it sitting. Fits both Fj60 and Fj62. Perfect for v8 swaps to use the 3” inlet cap from an 80 series. Includes the elusive fender inlet hose and mounting clamp. Box is missing one lid clamp but if you...

Anyone have guidance or a link for air locker troubleshooting? I finally got my new to me 80 out on trail and got myself hung on an obstacle where my locked front should have pulled me through. My friend said the front wasn't turning despite being fully locked according to switches and...

So I posted another thread a few months ago about rough idle and stalling. I narrowed it down to the connection of the wire harness with the MAF. I was able to find a new OEM connector from my local Toyota and replaced the wires with OEM as well. Unfortunately it didn’t help the loose connection...

Has been sandblasted and primed. The brown is dust from sitting in storage. I spaced wiping it down before the photo. Has some pitting on top from before the blastingI’ll add a close up of the pitting. But still would be a nice piece Need sitting in my stash for 3-4 years. Has a new air filter...

I'm not sure if there's a problem with my LC200, or if this is "just how it is", but, if I turn on the between-seats refrigerator, this of course engages the A/C compressor, and then I get cold air blowing into the car. Is that normal? If I just wanted non-chilled outside air blowing in...

Not sure what it’s called. 200.00 before shipping.

Has anybody seen a switch that looks like it belongs on an 80 dash, with a graphic for an on-board air system ?

1993-94 80 series air filter can. Looks good works great. $70 plus the ride.

I looked around a bit on the forum and I haven't been able to find the answer to my question. If there's another thread with the answer feel free to point me to it. I'm trying to figure out the best model number order for Air Lift or Firestone rear coil airbags. I have the Ironman 4x4 FCP "2...

That's what I want . Read lots of info here , seems like a hodge-podge of ideas with no clear way . Is there a shop around within a few hundred miles who can do this ? Thanks for y'all's help

Posting here because it’s 24 volt. Brand new in box. Comes with wire harness and toggle switch. $550 + shipping Have manifold kits too if you need to hook up lockers

Air cleaner with new air filter $140 shipped US Has some pitting in the top. But it’s been blasted and primed. Tank cover, evap line cover, tank fill hose $130 plus shipping. Not sure what that will run due to size. But we can figure it out. Maybe someone local will need one. Speaker cover...

From my 84 2F. $75 plus the ride from 49459.

My 2010 LX is mostly flawless. When I got it a year ago I had a local service tech baseline a few things, but nothing A/C wise. When I picked it up and got home a year ago I realized no air flow was coming from driver vents. Odd. A few days later, magically it started working again and has...

Aire cleaner housing from an Fj60. The lip appears to be deformed slightly in one area, although you wouldn't notice it unless looking for it. The hole for the carburetor stud is a little wallowed out, see photos. $100, buyer pays shipping.