Nbest

The connector housing and individual terminals are still available. Housing part # 90980-10071 for about $11. Each replacement terminal comes with 160mm pigtail. Part # 82998-12130 for about $7 each.

The VAF has been discontinued and trying to find a known good one is hard, once you do find one squirrel them away. Also I would find a known good harness and replace the whole thing. Not saying yours is but the harness over time will melt and...

The two I have were from trucks that had been sitting so long rats or squirrels got to the wiring. No hope for them other than cutting pigtails

I can supply a used harness ($$$$) or I can cut a pigtail off for you to splice in yourself. I think I only have one good OBD1 harness and 2 I am cutting up.

Try @slow95z and @arcteryx for used harnesses.

Are the WIRES failing or did someone undo the screws and yank on the wires, killing the VAF? My bet is the latter. There is a place that claims to rebuild the VAF, but not many have used them for reviews. I don't recall the name of them right...

It’s definetly the wires. Just south of the connector, maybe 1” or so. When you press them or slightly wiggle it, the engine will stall. I can maybe cut and splice with new wire, but being so close to the connector I’m not sure if I will have...

Hey everyone, I have failing wires at the connector to the VAF Sensor, which is causing poor acceleration and stalling at idle. Ive searched for a part number for the connector and wiring with no success. I don‘t think a new VAF sensor comes...