2F, de-smogged, Weber 38 carb, headers, 92,000 or 192,000 miles. I’ve had it for 18 years. I’ve never rebuilt an engine, but rebuilt everything else on here over the years.
Small oil leaks have gotten bigger, valves have slowly gotten more noisy than normal (despite valve adjustments and...
I have listed this 1969 Toyota Land Cruiser FJ55 on behalf of the owner. Upgraded to a 2F engine and 4-speed transmission.
I've had the truck in my possession for the past few months. A very rust free example.
Take a look.
https://bringatrailer.com/listing/1969-toyota-land-cruiser-fj55-4/
Long time guest and finally joined the group. Picked up a 77 Fj40 many months ago that someone wasn’t able to get back together. So much good info on here that’s been extremely helpful so far.
The engine was full of water when I bought the project. Still working the breaking it free but in...
As titled. I’d rate the powder coat job a 8/10. Really good but not show quality.
$150 + shipping OBO. I can get pretty good ship quotes provided an address and some details.
Guys I’m hoping someone might have an engine stand they aren’t using they’d be willing to loan out for a few months. I’d like this project to be wrapped up by thanks giving but I may need to dip into early December looking at the project honestly.
I can buy one for sure it’s just one more...
Trying to properly desmog my 86 FJ60 2F which was half a$$ desmogged by a previous owner. Having trouble sourcing a rebuilt aisen carb and recurved distributor. Any ideas?
Looking for a decent crankshaft. Going to be getting machined so condition not a concern as long as it hasn’t spun a bearing too bad and isn’t super rusty on seal surface.
Also if someone has a junk crankshaft please reach out as well as I have uses for that too.
2F engine side cover with dimple for large cap distributor. The outer side of the cover is pitted but the cover is solid, no rust. $90 local pickup or $120 shipped within continental US.
I’m in need of a useable 2F camshaft. I had mine reground by Delta Cams, and we’ve been having an issue with one of the lobes having a considerably smaller base circle than the rest. It’s causing major difficulties with valve lash and noise.
Welding the entire lobe isn’t really an option due...
So...This is a project I was forced to. We bought the 1985 FJ60 in 1990 as a family car with 90K miles for $6000. Family trips were two weeks in the wilderness doing off roads and camping in BLM and NF. In 1994 we took it to the Arctic Circle with a 9 years old boy, two girls 5 and 3, and an...
I just purchased a valve cover seal for my 72 and after doing so, I read multiple times that using a cover from a 2F would seal much better. I have sourced the cover below for $40 plus shipping. Does that price seem reasonable and will this work for my 72?