Looking for 1958-1966 1F rocker arm stud (holds down valve cover as well) (2 of those ideally), and 1 rocker arm stand. parts #33 and #27 in the diagram below. thanks!
Im near Lake Tahoe so west coast preferred.
Looking for a winch bumper for a 100 LX470. Keeping a tight approach angle is important to me so nothing that sticks out or is heavy/bulky. A Dissent...
I am searching for a drivers side (long side) rear axle shaft for my fj60. Located in central Florida and can pick up or figure out shipping if you are willing.
Thank you,
Kellen
hey everyone, looking for a tachometer for my Euro HDJ80 5 speed. Seems as thought they were all the same across the 1HD-T, but mine stopped working. if anyone has a working one, i’d be happy to...
Looking for a set of 18" factory LC wheels from 2006/2007.
Anyone have a set of these they're willing to part with?
I'm located in Portland, OR
Thanks!
Searching for OEM floor mats for a 1993 HZJ75 Troop Carrier.
Will entertain any colors at this point.
I need the front one the most.
Current color in my troop carrier is Sable.
I know its a long shot since it's been over a decade since FN Wheels used to sell the 5x150 exclusive Weds Adventure Hase Spec wheels, but if anyone has any they want to sell-please private...
Looking for something that probably doesn't exist. A new old stock 3 speed input shaft with clean clutch splines and no pitting or fretting on the gear.
Reverting a FJ40 to OEM+ and using a World Spec Carb and need gas pedal with all linkages (including ones going to the carb).
I'm located in Florida but willing to pay for shipping and handling...
Hey everyone, I'm looking for an oztent in fair shape. Really anything on the larger side of the RV3/4/5 line. I'm located in Las Vegas but open to driving anywhere in the general western US for...
I am looking for a replacement amplifier for my 2008 Landcruiser. The one I have has started intermittently cutting out on one side of the vehicle and also is low on output. Normally you could...
Looking for a Specter Off Road styled Brush Guard. I had one on my previous rig (pictured) that I sold. Picking up a new FJ40 and desperately hoping to find another one. If it's the correct model...
Looking for replacement locking hubs for an FJ60 or FJ62.
I recently did a knuckle rebuild only to find that one of the internal gears was missing from my driver side locking hub.
I guess I am...
Looking for a couple of these little clamps (P/N 90461-08060) that secure the heater hose to the upper pushrod cover. Anyone have any spares that they can part with? Thanks!
Looking to take my LX450 back to its original factory look. My refinisher just let me know my current factory set is too far gone to save, so I’m hunting for a replacement set.
I currently have...
Per the title...looking for a set of 3FE (FJ62) exhaust manifold heat shields in good condition, not crumbling apart.
Recently removed mine and the lower bolts holes have rusted crumbled away...
Looking for a throttle bellcrank assembly from a BJ60, HJ60, or Non US spec FJ62.
Part numbers: 78160-90A01, 78160-90A02
See picture below. It is the part circled in green:
Looking for an aftermarket roof rack for my 80 series. I’d like something with the look of a Prinsu, Victory 4x4, Bowfin.
Open to see what’s out there & willing to pay for shipping.
WANTED: LX570 Cargo Cover (OEM retractable one)
Someone out there in IH8MUDland has to have one of these in the garage corner or attic they want to get rid of.
OEM PN 64910-60240-C0
Willing...
Reviving this ad as the original was archived.
PO removed my fuel return line and installed an aftermarket carb. Going back original and need a return fuel line to either use or at least to use...
Reaching out to anyone that may have the OEM LX570 crossbars that came on a lot of 2016+ models. In San Antonio TX, but willing to pay for shipping. Looking for the crossbars and all associated...