Turns out my problem with the brake lights was a loose connector on the fusible link. Pulled a rabbit out a hat and made it work. Thanks again for the guidance.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Got a new for for ya'll. Now the headlight switch clicks twice and headlights turn on with the hazard switched on, but no hazards and horn. Hazards switched off, only running lights and turn signals. FML haha.
Same issue here mine is a 12V. Did you ever figure it out?So I finally got around to swapping the relay with a new one.
I am having the same issue. On the Passenger side, low beam at the light I am getting 3.5VDC. High beam, both low and high at the correct 12VDC engine off. This is metered in the connector for the headlights with my Fluke meter. Driver side works as it should? Ideas? Seems like a ground issue on the passenger side, but why only in low beam mode?
I am also having issues with the relay kit for headlights but it is disconnected now till this is fixed.
I just noticed that the high beam dash light does not come on. High Beams do though.