I think from order to delivery was 5 weeks.
What have you done to your 200 Series this week?
- Thread starter MScruiser
- Start date
-
- Tags
- 200 series
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Power steering pump restoration, new high and low pressure hoses, new reservoir, fully bled power steering rack.
Okay, finished product with RRW 17x8.5 0 offset wheels, Falken Wildpeak AT4 285/70 17 and the E&E 13mm spacer on front strut. I could not be more pleased with the stance. Gained about 1.5in in the front and the rear is only sitting 1/2 inch higher.
Damn they chunky haha
Any rub on 0 offset? How's the poke down the side? Looks great.
Rubbed on the front mud flaps, just removed them. Still rubs slightly on the bottom corner of the fender liner on the front, going to either trim some or see if I can push it forward some but it’s nothing crazy. I will get another pick of the poke in a bit
Yes sir! The Falkens measured the largest 285/70 17 I could find and they are a C load so they don’t ride terrible.
Those tires look alot bigger than 32.7".
Yeah they do, but I have same tires and I think it’s the 17” wheels that make the tire look larger than life.
Even though it's a profile shot, I could tell they were 0 offset just by the amount of daylight on the tire 
When I looked on tire rack they measured a true 33 by 11.5
New oem intake gaskets, bypass hoses, vacuum hoses, polished TB butterfly surface wrapped it up with ceramic coating the intake plenum exterior surface.
Offsets confuse me..
So 0mm offset from 60mm stock is like a 2.36" spacer?
Yes exactly. That is why most people say stick to 25-35mm offsets if you want to do something other than stock.
When you have a chance, can you please post front and rear views to show how much they poke out.
Can we get a shot down the side? I am looking at same offset for mine. I am being an offset perv. Looks good too!