What Did You Do With Your 120 Today? (14 Viewers)
- Thread starter kbahus
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Ah, sounds like our position. Previous owner actually put springs in but not the correct hardware. It makes for some interesting noises. No need to clean them on my account, the next wave of rain will just dirty them.
This morning I got a quote for new brakes and rotors, valve cover gaskets, coil packs and plugs for my 04...
$990.
I was pleasantly surprised.
$990.
I was pleasantly surprised.
Well, with the GX in view, we ordered OME kit along with coil conversion hardware. In the meantime, I replaced the engine air filter and greased the zerks before it heads off to the shop for a new water pump and timing belt tomorrow.
Sweet burley mudflaps!
I'd suggest trimming the top at an angle (rally-spec).
nice clean look.
BTW, love the sliders and how you trimmed the front part of the side step is cool.
Nice!
Get the Moab are wells and massey books too (since wheeling CO, you'll be over here soon enough to run trails... begin the library!
I've pulled my running boards but no sliders or skids yet, you gain like 3" of side clearance w/o the running boards (from post tire breakover)... I've wheeled some Moab bmoderates in otherwise stock '07 (plus tires).. you'll be surprised and impressed at what these things can do stock! It keeps blowing my mind!!
Rock on!
sport wheel! black birdseye maple!Thanks for the pics, that looks nice for us non-smokers! I think I'll order the same. Take a pic of your overhead console!!
I just got my hands on an Alphard OEM steering wheel with all the controls i wanted....direct swap but I was only interested in the buttons. Now that it's arrived, I'm thinking it would look nicer than my current wheel.
View attachment 1751335
what's this for?
what's on your list for a front leveling kit/lift? inquiring minds...
doh! Whish i'd've had time and known. Just flew through from Lincoln, NB to Moab last Monday...
passed the tornado debris in Brush...
it was crazy... Whole roof of the shell on the north side of the interstate was ripped off...
NMBruce
SILVER Star
did some cleaning, but I think it will get done again, dirt everywhere
Going to be a busy week next week. Received the under armor for my sensitive bits, rear coils and shocks. Brake parts and remaining suspension should be in next week.
The local shop finished changing my timing belt and water pump, which they thought was the original one, just 70k past due. The shop discovered my brakes are far gone so new pads and rotors en route. That what you get when you buy from auction I guess...
The local shop finished changing my timing belt and water pump, which they thought was the original one, just 70k past due. The shop discovered my brakes are far gone so new pads and rotors en route. That what you get when you buy from auction I guess...
Installing new Denso radiator tomorrow with new OEM upper and lower hoses and Toyota red coolant. Everything ended costing $315.00. Dealer wanted $1095.00 to do it. Cross your fingers for me!
Just got it done last night. Did the Bilstein 5100 all round. Front is ome 883 on the lowest perch.
Last edited:
Sweet burley mudflaps!
I'd suggest trimming the top at an angle (rally-spec).
nice clean look.
BTW, love the sliders and how you trimmed the front part of the side step is cool.
Thanks for the compliment! Never thought of trimming the mud flaps like that. Good idea.
Successfully installed new radiator!
I got my Power Tray and Bussmann relay/fuse panel installed, as well as stripped my Viair 300P down to barebones and installed it. Now just need to do some wiring and install my new console switch plate.
Went exploring to escape the heat and smoke. Found some fresh air up in the Carson Pass area!
