Steering linkage question…

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

imyahucklbrry

“In Vino Veritas”
SILVER Star
Joined
Jan 29, 2014
Threads
73
Messages
1,668
Location
GA - As close to the lake as I can afford...
Got a manual Saginaw set up on my ‘82 (PO’s) that needs addressing since I’m keeping for the time being….. going to replace a slightly bent relay rod (drag link to some) and possibly go with a little shorter pitman arm
Current rod is 26” (no idea where it came from) @cruiseroutfit has a 25.5 and 26.75 length and I’m trying to decide whether to go shorter or longer?
Picture for reference…. There’s roughly 3/4” of thread on both sides with current 26” rod

Question is: It better to have very little TRE threads exposed or slightly more than my current 3/4?

Thanks ahead……

90937323-140B-4000-AAA9-5B41CDD26A7B.webp
 
I prefer less threads showing. Proper toe in is the most critical measurement, then see what threads are exposed. You need to cut those ubolts.
 
I prefer less threads showing. Proper toe in is the most critical measurement, then see what threads are exposed. You need to cut those ubolts.
Thanks - Just added 4 degree shims to front and the longer U Bolts were added after the standard length bolts seemed a bit short……. trimming is next!
Correct toe in was already set ;)
 
If that is a saginaw then the rod is odd length to you because it was custom
Made when I do a saginaw conversion I cut the right hand thread Toyota end off and shorten rod and tap it to accept the Chevy tierod end.
To attach it to the Chevy pitman arm.
Custom rod Toyota tierod one end and Chevy tierod on the other.
 
Guessing that since the Saginaw conversion is common, there are plug n play parts available….. I took some measurements and think that the 26 3/4 length of relay rod might be the better choice over the 25 1/2 although it leaves very little room for adjustment. I agree that covering as much of the threads as possible is safer!
Thanks for your input!


581DB4E4-001F-41DC-B649-86943F9173DE.webp
F2FDD130-5D80-4C04-962D-3013684E45A4.webp
 
Put anti-seize compound liberally on all the threads (M and F) before you assemble. Your future self will thank you the next time you do an alignment.
 
Most vendors have the conversion rod with metric and sae for saginaw set-up .
Longer rod is better , you can trim 1/8" at each end if need
Thanks….. you answered another question I’d thought about! (trimming)
:cheers:
 
.
4DB7F326-B136-4C18-8242-CA5294DDEDAA.jpeg

:meh:
 
Back
Top Bottom