My kits are designed specifically for the later split cases. AA makes the twin-stick kits for the earlier one-piece cases. I do sell them, pm me if you're interested. $189 plus shipping.
Well, I got the kit installed and am happy with the improvement. Here is a picture of the shifter boot.
My only issue is that the sound insulating properties of this shifter boot are not very good. I am looking for alternatives - I recently insulated the floor with CruiserCrap and now the only noise in the cab is from the shifter boot...
Any ideas?
Dan
P.S. The shop switched the knobs... I switched them back.
If you want mote noise reduction and insulation, then there's a couple of things you can do. I would start with a flat sheet of rubber either 1/8" or 1/4". Drill your four corner holes and then cut two slots for the shifters. Use that "boot" first. Then bolt the double boot down over the flat rubber boot. It'll help quite a bit. If you want/need even more, then put some soft foam padding between the two as well. Just make sure you don't limit the linkage or shift lever throw.
Hi I'm Benny from Indoesia
I interested the Kit for 5 transmission.
Do you ship Internationaly and accept pay pal?
If yes, I need your help to calculated shipping cost to Indonesia.
Thank you
Hi I'm Benny from Indoesia
I interested the Kit for 5 transmission.
Do you ship Internationaly and accept pay pal?
If yes, I need your help to calculated shipping cost to Indonesia.
Thank you
hey benny.
thanks for the replies. are you installing a 5 speed h55f in the cruiser and converting the transfer case to manual shifting? do you have the parts for the transfer case?
international shipping is not a problem.
hth
georg @ valley hybrids
Unfortunately I don't have parts for the transfer case.
Can you explained with picture everything is needed to converted
If can, I need all parts for that.
Converting from vacuum shifter to manual shifter.
Thanks
Sorry, I'm new about this.
can you show me where I need to drill and tap the case.
i want to order a twin stick and the shifter knob with the symbol like this but in alluminium.
and this one
if you can help me i need the rubber too like this.
i believe you more expert than me, please chose the right system for my trans.
do you accept pay pal?
Thank you
hey benny.
thanks for the reply and pics. i have everything you're looking for in stock, pm on the way. international shipping won't be a probelm.
hth
georg @ valley hybrids