For Sale Landcruiser fire truck rear PTO, SoCal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Mark,

I'll take the 16 spline 4 speed version since Fernan needs the 10 spline 3 speed version.

$350 with shipping, correct?

Thanks
Ernie
 
Mark,

I'll take the 16 spline 4 speed version since Fernan needs the 10 spline 3 speed version.

$350 with shipping, correct?

Thanks
Ernie

Ok, we are good to go. Instructions the same as post 11.
 
Hi,
I confirmed. The one I need is a 10 spline. So, can please send me that version? And sell the 16 spline to ernram.

Fernan

Thanks for the confirmation.
 
Mark,
Funds just sent via PayPal. Please confirm you got it and the shipping to my mechanic in El Paso Texas
 
Best view of the shafts
Screenshot_20170821-190641.webp
 
I don't assume you have the rear driveshaft, do you?

Looks like post #9 in the link below.

45 power take off, info request | IH8MUD Forum
45 power take off, info request

Thanks
Ernie

I have had about a half dozen of these total. I believe that ONE of them had the mating flange of a driveshaft still attached, which i separated and put on the shelf near the gearboxes. If I have it, it's available for $40 extra. LMK
 
I have had about a half dozen of these total. I believe that ONE of them had the mating flange of a driveshaft still attached, which i separated and put on the shelf near the gearboxes. If I have it, it's available for $40 extra. LMK

Mark,

Please look around for as much of the shafts /brackets that match the pictures above. I'll pay your fair price.

Looks like 4 total shafts in total.
Screenshot_20170821-211929.webp


Thanks
Ernie
 
Post #27 above with the yellow picture is the closest thing i have ever seen to what the entire assembly of shafts and pillow blocks looks like
 
Shaft 37660 seems to go from center PTO to the first 37210 block that hangs on the shock support member via Ubolts. Then shaft 37630 bridges to the other 37210 block that exits the back and that is supported with a bracket 37216.

So it's 2 shafts, 2 pillow blocks and a bracket I seek.

Thanks
Ernie
 
well I looked around a little more today. The flange I spoke of doesn't fit any of the PTO's; now I don't remember what it was from! It looks like it could be a 37210 from your diagram, but that doesn't make any sense to me because I never had any of the parts in between.

But I did find a complete 37611 joint. Good condition. $80. Can ship in the same box with the PTO.

That's all for now. LMK
 
Mark,

Can you post the pictures here of what you have and that way I know what I'm dealing with?

Thanks
Ernie
 
Back
Top Bottom